Operating Guide

ASSEMBLY

- 4 -

2c. To hold the tripod base in position during this

procedure set the backstop as shown.

2d. When the frame is correctly positioned on

the tripod base release the backstop.

3. To move the winch into the working position

rotate the winch forward slightly with your right hand

while raising the brake arm with your left hand.

1. Begin by setting up the tripod base: press down

on the slide yoke ring pin and swing the outer legs

out until they lock in the working position (note the

holes on the bottom of the slide tube).

2a. Place the frame assembly on the tripod base.

2b. Pocket “A” slides OVER angle “B” while

angle “C” slides INSIDE angle “D”.