Operating Guide

22
Removing the Motor:
(Only to repair, maintain, or replace)
WARNING: The guards on the saw motor have been modified specifically for use on the Panel Pro.
NEVER use the saw motor as a hand-held unit.
To remove the motor from the turntable:
1. Disconnect and lock off the power supply.
2. Remove the blade guard.
3. Remove the saw blade.
4. Support the motor by hand, and loosen the rear motor mount nut.
5. Remove the two lower nuts and bolts from the saw mounting bracket/foot.
6. Remove the upper nut, bolt and spacer from the saw mounting bracket/foot.
To reattach the motor, reverse the above procedure.