Operating Guide

16
tube further in (the slot will fit around the blade), until it is as close to the work piece as possible. Tighten the
clamp to hold the inner tube in place.
2. Mount the hose rollers to the top of the frame.
3. Lay the 1
1
/
2
” (40.6mm) black flexible vacuum hose across the rollers, with one end to the front of the frame and
one end to the back of the frame.
4. Connect the hose end that is toward the back of the frame to the vacuum (see specifications).
5. Connect the hose end that is toward the front of the frame to the narrow end of the steel tube elbow.
6. Connect the tapered end of the steel tube elbow to the outside of the plastic dust tube.
Your Panel Pro is now assembled and ready for operation.
Refer to page 17 for basic operation instructions.