Operating Guide

15
Installing the Wheel Accessory
Attaching Dust Collection Kit (optional accessory)
Dust Collection Kits are recommended if the tool will be used in an enclosed area. They include discharge tubing
and a hose roller system to hold the outboard end of the tubing.
The dust hose must be attached to an SSC Vacuum or to any high-pressure vacuum source that provides at least
90” to 110” of static pressure and 100 CFM.
All machines come standard with a 2” (50.8mm) hose connection on the blade guard.
Installation
Refer to Figure 39.
CAUTION: Before beginning installation, disconnect the power supply to the motor, raise
the carriage to the top of the guides, and lock the carriage in place with the
lock knob.
CAUTION: Be sure the tool frame is securely supported and cannot be tipped over during
this installation procedure. An additional person should support and stabilize
the frame at all times during the installation.
Figure 39: Installing the Dust Collection Kit on a Saw
1. Insert the clear plastic inner tube into the blade guard, and align the tube’s slot with the inner tab. Slide the
Hose Roller System
Dust Hose
Dust Collecting Bonnet
Dust Tube
Dust Elbow
Washer
Bolt