Installation Manual

For Technical Support: http://www.panduit.com/wcs/Satellite?pagename=PG_Wrapper&friendlyurl=/en/support/contact-us

INSTALLATION INSTRUCTIONS

V00028NW

Page 8 of 12

INSTALLATION INSTRUCTIONS

Removable Gland Plate

The Gland Plate, located on the bottom of the enclosure, is removable for machining to accept bulkhead connectors or compression

fittings. Remove (12) screws and (12) flat washers on the bottom of the enclosure to remove plate from the enclosure. Accommoda-

tions for incoming conduit have been supplied on the enclosure. A 1/2” conduit plug is installed in the recommended incoming

power location. Recommend installation of IP66 rated conduit fittings that comply with the IEC codes that are applicable to the

intended application. When reinstalling the gland plate, ensure the screws are tightened until the gland plate flanges make contact

with the enclosure surface.

Gland plate

Plug