Installation Manual

For Technical Support: http://www.panduit.com/wcs/Satellite?pagename=PG_Wrapper&friendlyurl=/en/support/contact-us

INSTALLATION INSTRUCTIONS

V00028NW

Wall Mounting Bracket Installation

Step 1: Turn enclosure on its side with the locks orientated

towards the top. Using Latch Tool, turn both locks towards

each other to open door.

Step 2: Install Wall Mounting Brackets into back of the enclo-

sure aligning threaded studs on brackets to holes located in

back of the enclosure. Be sure obround mounting holes on

the wall mounting bracket align outward.

Step 3: Secure Wall Mounting brackets using sealing washers

and (1) per threaded stud.

Torque spec:

Steel Enclosure: 5/16" washers = 30 in-lbs

Stainless Steel Enclosure: 3/8" washers = 40 in-lbs

Step 4: Close Door. Using Latch Tool, turn both locks to

secure the door.

If Mounting Flanges are not used:

For Steel Enclosure: Use 5/16" Sealing Washer (supplied) and

a 5/16" Bolt (not supplied) in the locations where the

threaded studs in the mounting flanges would go to mount

enclosure directly to wall.

For Stainless Steel Enclosure: Use 3/8" Sealing Washer (sup-

plied) and a 3/8" Bolt (not supplied) in the locations where

the threaded studs in the mounting flanges would go to

mount enclosure directly to wall.

Latch Tool

Wall Mounting Brackets

Sealing Washer

Hex Nut

Detail View

Step 1

Step 2

Step 3

Note: The enclosure may be mounted to the wall without the mounting brackets

Washer

(provided)

Screw

(not provided)

Page 6 of 12