manual

INSTRUCTIONS CM599D

For Technical Support: www.panduit.com/resources/install_maintain.asp

Page 13 of 22

Top Hinge Bracket

[2] M4 Screws

(use 2.5mm Allen Key)

Bottom Hinge Bracket

M6 Torx Screw

(use T30 Torx bit)

[2] Hex Nuts

(use 8mm socket wrench)

PANDUIT Label

Door

Handle

Backing

Plate

Door Handle

(rotate 180º)

Door Catch

Door Cam

(reposition to

outside edge

of door)

Single Hinge Door (Door Handle Direction Reversal)

• VIEW 1, 2 Remove Top and Bottom Hinge Brackets from current location (remove top hinge screw, if necessary)

• VIEW 1, 2 Install Top and Bottom Hinge Brackets on opposite side of cabinet (re-install top hinge screw, if necessary)

• VIEW 3 Move Door catch to opposite side of cabinet frame

Door Handle Reversal (Lay door on a flat surface) - VIEW 4, 5

• Remove Door Handle Backing Plate and rotate position of Door Handle 180º

• Loosen Cam Screw to reposition Door Cam and Cam Stop to outside of door. Tighten Cam Screw

• With Door Handle repositioned, secure Door Handle Backing Plate to Door Handle

• Remove PANDUIT label and re-attach in correct orientation near top of door

• Reinstall Single Hinge Door per instructions on Page 12