Installation Manual

INSTALLATION INSTRUCTIONS

For Technical Support: www.panduit.com/resources/install_maintain.asp

CM599L

Page 26 of 27

Top of Cabinet Cable Manager Installation (for vertical exhaust ducts)

IMPORTANT - INSTALL VERTICAL EXHAUST DUCT PRIOR TO INSTALLING REAR VERTICAL WALL

• Disassemble front fascia assemblies (packaged in cabinet) by removing (2) M5x0.8 button head screws (use T25 Torx bit).

• Remove (2) M5x0.8 button head screws (use T25 Torx bit) from front of Cable Manager base.

• Install vertical wall on front of Cable Manager base using (5) M5x0.8 button head Torx screws (use T25 Torx bit). Re-install screws

from previous step to secure to the frame.

• Attach front fascia to the front vertical wall by sliding fascia over studs in vertical wall.(see detail view). Tighten with (4) M5x0.8

• button head screws

• Attach rear vertical wall to the Cable Manger with (4) M5x0.8 button head screws (use T25 Torx bit) from underneath Top of Cabinet

Cable Manager.

Studs

Front Vertical Wall

- Remove -

[2] M5 Torx Screws

(use T25 Torx bit)

[5] M5 Torx Screws

(use T25 Torx bit)

Front Vertical Wall

Rear Vertical Wall

[4] M5 Torx Screws

(use T25 Torx bit)

[4] M5 Torx Screws

(use T25 Torx bit)

IMPORTANT

VERTICAL EXHAUST

DUCT MUST BE

INSTALLED PRIOR TO

INSTALLATION OF

REAR VERTICAL WALL