Installation Manual

INSTALLATION INSTRUCTIONS
For Technical Support: www.panduit.com/resources/install_maintain.asp
CM599L
© Panduit Corp. 2016
Page 17 of 27
Top Hinge Bracket
[2] M5 Torx Screw
(use T25 Torx bit)
Bottom Hinge Bracket
M6 Torx Screw
(use T30 Torx bit)
[2] Hex Nuts
(use 8mm socket wrench)
PANDUIT Label
Door
Handle
Backing
Plate
Door Handle
(rotate 180º)
VIEW 1
VIEW 2
VIEW 6
VIEW 5
Door Catch
VIEW 3
Door Cam
(reposition to
outside edge
of door)
Single Hinge Door (Door Handle Direction Reversal)
• VIEW 1, 2 Remove Top and Bottom Hinge Brackets from current location (remove top hinge screw, if necessary)
• VIEW 1, 2 Install Top and Bottom Hinge Brackets on opposite side of cabinet (re-install top hinge screw, if necessary)
• VIEW 3 Move Door catch to opposite side of cabinet frame
• VIEW 4, 5 Remove Horizontal Grounding Bracket and reinstall on opposite side of door.
Door Handle Reversal (Lay door on a flat surface) - VIEW 5, 6
• Remove Door Handle Backing Plate and rotate position of Door Handle 180º
• Loosen Cam Screw to reposition Door Cam and Cam Stop to outside of door. Tighten Cam Screw
• With Door Handle repositioned, secure Door Handle Backing Plate to Door Handle
• Remove PANDUIT label and re-attach in correct orientation near top of door
• Reinstall Single Hinge Door per instructions on Page 15
VIEW 4
M5 Torx Screw
(use T25 Torx bit)
Horizontal
Grounding
Bracket