Installation Manual

INSTALLATION INSTRUCTIONS

For Technical Support: www.panduit.com/resources/install_maintain.asp

CM599L

Page 11 of 27

Equipment Rail Adjustment

• Loosen M10 Hex Head Screw at top and bottom of rear equipment rail

• Adjust equipment rail to desired positon

• Tighten M10 Hex Head Screw to 30.0 +/- 5.0 N-m [22.1 +/- 3.7 Ft-lbs]

NOTE: Front equipment rails are in a fixed position

Uninstall/Re-install and Move Equipment Rails (Top and Bottom Locations)

• Remove [2] M10 Hex Screws at top and bottom of Equipment Rail

• Remove [2] Equipment Rail Mount Nuts through slots of Front-to-Back Beam

• REVERSE STEPS to re-install Equipment Rails (insert Equipment Rail Mount Nuts through slots of Front-to-Back beam while holding

finger grip of mount nut; ensure that barbed surface of Equipment Rail Mount Nut faces outside of cabinet)

TOP AND BOTTOM

M10 Hex Head Screw

(use 15mm socket wrench)

UNINSTALL/RE-INSTALL AND MOVE EQUIPMENT RAILS

M10 Hex Head Screw

(use 15mm socket wrench)

Equipment Rail

Mount Nut

Slot of Front-to-Back Beam

Equipment Rail

Mount Nut

(Finger Grip Area)

Barbed Surface

(face to outside

of cabinet)

FALLING EQUIPMENT HAZARD

Remove all equipment installed onto equipment rails before performing any adjustments to equipment rail spacing.

FAILURE TO FOLLOW THESE INSTRUCTIONS CAN LEAD TO SERIOUS INJURY, DEATH, OR DAMAGE TO YOUR EQUIPMENT.

WARNING