Instruction Manual

© Panduit Corp. 2022
INSTALLATION INSTRUCTIONS
CCAL2H/CCPL2H Family of Cable Cleats
RW318
Rev. AB [12-2022]
DOC#: RW318 Page 2 of 5 Rev 00 [05-2022]
Email:
[e-mail]
EU Website:
www.panduit.com/emea
EU Email:
emeatoolservicecenter
@panduit.com
www.panduit.com
Panduit Corp.
USA Technical Support
Tel: [phone]
Panduit Europe • EMEA Service Center
Tel: [phone] • Fax: [phone]
Preparing for Order
Step
Picture
Description
1
Contact Panduit Sales for
assistance with Cleat and
hardware selection.
2
Measure actual diameter of
the cables. Select a cleat part
number based on the actual
diameter of the cables.
3
Measure height of the ladder
rung. Procure M10 or 3/8”
washers, nylon-insert
locknuts, and hex bolts with
sufficient length to pass
through the ladder rung and
cleat with the cables installed.
Dock washers can be used to
span the opening at the
bottom of the rung if there is
insufficient clearance between
the flanges.