User manual
Table Of Contents
- SmartZone™ Network-Enabled M Series Rack PDU
- Equipment Overview
- Pre-Installation
- Installation
- Mounting
- Hardware
- Graphical User Interface
- Setup
- Input Sensors
- Power
Network-Enabled M Series Rack PDU User Manual
- 34 -
Access Permission Settings
Read Only Permits the NMS to use only GET commands
Read / Write
Permits the NMS to use both GET and SET com-
mands
SNMP Receivers
The SNMP Receivers page displays information for all devices that receive SNMP traps
sent from this unit.
Enter the IP address and Community String for any device that will be required to
receive SNMP traps. Usually any SNMP NMS entries should also be entered here.
From the dropdown menu under Receive Traps, select one of the following:
Receive Traps Settings
Disabled Receiving traps is prohibited
Enabled
Allows the specified NMS to receive the unit’s standard