User manual

Network-Enabled M Series Rack PDU User Manual
- 24 -
The application stays in this mode for at least 5 seconds. If no button operation is detec-
ted, the application continues to normal system operation.
If the customer presses and holds the Mode button for 5 seconds, the following message
displays on the LCD:
Hold MODE button more than 5 seconds to reset to defaults
If the customer continues to press and hold the Mode button, the following message dis-
plays on the LCD:
Reset to defaults is detected. Please release MODE button.
The customer should release the Mode button at this point. The following message dis-
plays on the LCD:
Device is Resetting to factory defaults.
If the customer does not operate the Mode button as described above, the application
continues normal system operation.
Internal Error Notification
After system start up is complete, during normal operation of the unit, the LCD screen
may blink. This typically indicates a temporary or persistent internal error condition.
If the condition is persistent, the LCD screen displays the word "STATUS:" followed by a
hexadecimal code, similar to the following.
STATUS: 0x009000080
The hexadecimal code is a composition of per-outlet control, per-outlet monitoring and
per-phase monitoring status. For example, if a three phase Per-outlet Monitoring or
Switched unit loses a power phase, the status screen will reflect that communication to
those boards has been lost.
For definitions and recommended actions on status codes, provide the displayed hexa-
decimal number to Panduit Technical Support.