Installation Manual

10Gig™ SFP+ Copper Cable Assembly Installation Guidelines PN533B
Panduit Corporation, 2011 Page 4 of 7
Installing and Removing 10Gig™ SFP Copper Cable Assemblies
To attach a cable assembly, remove the purple protective EMI cap. Then simply insert the connector
end into the cage of the SFP+ host port in the active equipment. Make sure the cable is fully inserted and
engaged.
ATTENTION: Observe precautions for handling electrostatic sensitive electronic devices when installing
this product. Ensure that you are properly grounded with a wrist strap or equivalent while installing
10Gig™ SFP+ Copper Cables.
To disengage, gently pull the latch release and the cable assembly will easily disengage the port. The
Panduit
®
10Gig™ SFP+ Direct Attached Copper Cable Assemblies have been designed to fit into high-
density belly-to-belly faceplates.