Submittal

Data Center Wizard

The Room Grid screen may be accessed directly after the Format Selection screen if the Room Grid was selected

from the Application Selection screen, or is the first page you enter when clicking Next from the Application Selection

screen when the Data Center Project is selected.

This screen allows you to define one or more Room Grids in their data center.

Project: This field will allow you to select a specific existing project, or to use the default project. Default will be the

default. If you wish to create a new project, you will be prompted when exiting the wizard. Selecting a project from the

dropdown will populate the remaining fields on the screen with the values associated with that project.

Room Dimensions: You can define the room grid either by entering the X and Y dimensions (length and width) or by

entering the grid starting and ending coordinates. The unit of measure will change from feet (Ft) to meters (m)

depending on the current unit of measure in the main EASY-MARK application. When valid values are entered in both

room dimension fields, the Grid Start and Grid End fields will be automatically populated with the proper grid

coordinates. The assumption is that the grid cells are 24" square when in English units of measure, and 600 mm

square for metric units of measure. The grid fields will be blanked if you begin to enter information manually into the

Grid Start or Grid End fields, and will be automatically populated when valid data is present in both the Grid Start and

Grid End fields.

Tile Size: This dropdown will contain two entries: 24 x 24 in. and 600mm. If English units are selected, 24" will be the

default, while 600 mm will be the default if in metric.

Grid Start and Grid End: These fields may be used by you to directly enter the start and end coordinates of their

room grid. For example "AA01" to "AM08" When entering data into these fields, the Room Dimensions fields will be

blanked until valid values are present in both fields. At that point, the dimensions will be calculated based on the value

selected in the "Panel Size" dropdown below.