Submittal

31
Tools
Creating WireMarkers
When labeling wire, an often-used technique is to repeat or "stack" data several times on a label so the information can
be seen easily after the label is wrapped around the wire. Use WireMarker to automate this task for you.
EASY-MARK operates in two modes--Label mode and WireMarker mode. Toggle between the two modes by clicking
Tools | WireMarker Mode. Enter the text or series information you need and print the label.
The left corner of the Status bar at the bottom of the Main window indicates the mode you’re in. The Status bar also
shows you the format you’ve chosen.
When creating WireMarker labels, you may want to take advantage of the WireMarker Mode in EASY-MARK.
Toggle WireMarker Mode on and off by clicking the WireMarker Mode icon shown to the left. This will perform to repeat
all text on the label as many times as possible given the size of the label. For example, consider you have the below
labels created for marking wires.
By toggling on WireMarker Mode, the text on each label will be repeated as shown below.