Installation Manual

INSTALLATION INSTRUCTIONS
© Panduit Corp. 2017
E-mail:
[e-mail]
Phone:
866-405-6654
For Instructions in Local Languages
and Technical Support:
www.panduit.com/resources/install_maintain.asp
Page 1 of 1
www.panduit.com
NK382C
NetKey
Network Components
Keystone Cabling System
NKBPR**Y, NKBPB**Y
(R = Red Colored Ring)
(B = Black Colored Ring)
Front
Rear
Installation Options for Front of Module
Installation Options for Rear of Module
Option 3
A. Insert Banana plug straight into the
shaft on the front side of module.
Option 1
A. Strip off about 1/2" to 3/4" of outer jacket
from the speaker wire. Twist
conductor
strands together.
B. Remove termination cap from front side
of module by rotating counter-clockwise.
C. Insert the exposed portion of the speaker
wire into the side hole in the binding post
shaft.
D. Re-install termination cap by rotating
clock-wise until wire is secure.
Option 2
A. Strip off about 1/2" to 3/4" of outer jacket
from the speaker wire. Twist
conductor
strands together.
B. Remove termination cap from front side
of module by rotating counter-clockwise.
C. Curve exposed wire slightly. Wrap wire
around the shaft.
D. Re-install termination cap by rotating
clock-wise until wire is secure.
Option 1
A. Remove set screw from rear shaft.
B. Insert Banana plug straight into the shaft
on the rear side of module.
C. Discard set screw.
Option 2
A. Remove set screw
from rear shaft.
B. Strip off about 1/2" to
3/4" of outer jacket
from the speaker
wire. Twist conduc-
tor strands together.
C. Insert exposed
wires into shaft
on the rear side
of module.
D. Replace screw
and tighten until
wire is secure.
A
B
A
D
C
C
D
Speaker wire
C
D
A
NetKey Keystone 5-Way Binding Post Module
Part Numbers: NKBPR**Y, NKBPB**Y
Ring