Installation instructions

INSTRUCTIONS CM598G

For Technical Support: www.panduit.com/resources/install_maintain.asp

Page 13 of 28

Dual Hinge Door (Operation)

NOTE: Door is push-to-close. PANDUIT recommends closing handle after opening door and simply push door when closing

Door Function Adjustment (optimize door operation)

• Remove Dual Hinge Door from cabinet (or open one side at a time)

• VIEW 1 Loosen [2] Hinge Pin Screws at bottom of cabinet and raise by approximately 6 revolutions (6mm [0.25”])

• VIEW 2 Lower [2] Hinge Pin Locknuts to bottom of Hinge Pin Post Screw (if nut is not lowered; factory setting of nut is fully-lowered)

• Reinstall Dual Hinge Door (see page 15)

• VIEW 3, VIEW 4 Raise [2] Hinge Pin Locknuts until locknuts touch bottom of Dual Hinge Door, then lower locknut 1 revolution

• VIEW 5 Open each side of Dual Hinge Door and tighten [2] Hinge Pin Screws

• Close Dual Hinge Door

• If Dual Hinge Door interferes with Hinge Pin Locknut, lower locknut until there is no interference

Ensure BOTH swing handles are in

closed position prior to closing door

[2] Hinge Pin Screws

(Loosen and raise

6 revolutions)

[2] Hinge Pin Locknuts

(Lower)

[2] Hinge Pin Locknuts

(Raise until locknuts touch

bottom of Dual Hinge Door,

then lower 1 revolution)

Dual Hinge Door

[2] Hinge Pin Screws

(Tighten)

6mm

[0.25”]

1mm

[0.04”]