Installation Manual

For Technical Support: www.panduit.com/resources/install_maintain.asp
INSTALLATION INSTRUCTIONS
© Panduit Corp. 2018
FS128B
Page 13 of 16
FLEX-FCM1UA
FLEX-FCM2UA
FLEX-FCM4UA
The HD Flex Front Cable Manager is an optional accessory for
use with the HD Flex Patch Panel. The front managers include:
• #12-24 x 1/2" screws (quantity 4)
• M6 x 1.0 x 15mm screws (quantity 4)
• Bend Radius Clips (quantity varies by model):
4RU - 8 clips, 2RU - 4 clips, 1 RU - 2 clips
• 1 Roll of Tak-Ty
• Laser warning labels
Installation on equipment rail:
Figure 30
Partially threaded in
(one on each side)
Tightened completely
(one on each side)
After installing the HD FLex Patch Panel to the equipment
rails (using four screws for 2RU and 4RU variants and two
screws for the 1RU variant), the two screws in the very
bottom openings need to be partially threaded in and the
two screws in top holes are to be tightened completely (see
Figure 30, 4RU variant shown). Only the partially threaded
bottom screws are to be used for the 1RU variety.
Figure 31
Tighten bottom
screws completely
(one on each side)
Tighten completely
(one additional
screw on each
side)
Rest the HD Flex Front Manager on the two
bottom screws, then secure with two more
screws (as illustrated in Figure 31). The two
bottom screws can then be tightened.
Figure 29