Installation Manual

For Technical Support: www.panduit.com/resources/install_maintain.asp
INSTALLATION INSTRUCTIONS
© Panduit Corp. 2015
FS006D
Page 9 of 11
Drawer in home position
Figure 9C
Drawer in extended position
Figure 9B
Fixed Tak-Ty
Grommet
Route fiber through grommet as shown. Use
enough cable length to ensure one complete
loop (approx. 45" [1.15m]) of individual fibers
around FOSM slack spools.
Route 900µm buffered fiber from the trunk
cable and splice to pigtail per instructions in
FS001*, “Opticom Fiber Optic Splice Module
Installation Instructions.”
Leave enough jacketed slack so when the
drawer is fully extended the cables are not put
under tension. DO NOT use so much slack
that the drawer cannot be returned to its home
position (See Figure 9C).
Use Tak-Tys to secure fiber cords at cable
entry location and other points as shown.
Individual fiber
breakout point
(See fiber
breakout detail
on page 7)
Free-floating
Tak-Ty
Tak-Ty cables
to fence
Sub-unit
tubes
“A”
“B”
Cable length
between point
“A” and point
“B” is approx.
36" [.914m].
* Denotes instruction sheet revision letter.
Note: Cover not shown for clarity.
Note: Cover not shown for clarity.