Installation Manual

For Technical Support: www.panduit.com/resources/install_maintain.asp

INSTALLATION INSTRUCTIONS

FS006D

Page 8 of 11

Fiber Adapter Panels (FAPs):

Up to 4 for FEC1U & FCE1UA

Up to 8 for FCE2U

FOSM Fiber Optic Splice Module Installation (FOSMs not included)

Place “L” shape support brackets over

#10-32 studs on sliding tray, note orientation.

Place first FOSM on top of “L” shape support

brackets and secure with #10-32 hex nuts.

Remaining FOSMs are stacked on top of

each other and snap in place.

If 4 FOSMs are to be installed in the FCE1U

or FCE1UA, side latches on top module must

be broken off to close the enclosure drawer.

Position FAPs between upright flanges as

shown. Once mounted, fully seat NyLatch

fasteners to secure.

Break off FOSM latch

on top module only

Drawer shown fully extended

and tilted down

(cables omitted for clarity)

Fully extend drawer to ensure proper amount

of slack is used.

Finish splicing in each FOSM before

adding/stacking subsequent FOSMs.

FOSM:

Up to 4 for FEC1U & FCE1UA

Up to 8 for FCE2U

"L" shape

support

brackets

Figure 9

Figure 9A