manual

ManualsBrandsPanduit Manualschassis componentsDIFBA2002S00S

FOR TECHNICAL SUPPORT www.panduit.com/resources/install_maintain.asp

INSTALLATION INSTRUCTIONS

V00029ER

Page 1 of 4

DIFBA2002S00S

(installed in Net-Access

S-Type Server Cabinet)

Switch Inlet Duct

DIFBA2002S00S

Cisco Nexus 9396PX Switch

(reference)

Summary of content (4 pages)

PAGE 1
Switch Inlet Duct DIFBA2002S00S © Panduit Corp. 2014 INSTALLATION INSTRUCTIONS V00029ER Cisco Nexus 9396PX Switch (reference) DIFBA2002S00S (installed in Net-Access S-Type Server Cabinet) FOR TECHNICAL SUPPORT www.panduit.com/resources/install_maintain.
PAGE 2
V00029ER INSTALLATION INSTRUCTIONS Prepare Switch for Ducting Installation -Remove bottom screws from front of switch rails and discard. FRONT OF CABINET Install Cage Nuts -Insert [2] Bonding cage nuts per equipment rail in rack space immediately above switch rails, at front of cabinet [2] Bonding Cage Nuts (install in Rack Space above switch rails) Intended Mounting Location (2 rack spaces) FRONT OF CABINET For Technical Support: www.panduit.com/resources/install_maintain.
PAGE 3
V00029ER INSTALLATION INSTRUCTIONS Install Switch Ducting -Secure DIFBA2002S00S switch ducting to equipment rails with [4] screws -Do not tighten [2] bottom screws --- Leave slightly extended for Front Perforated Plate installation (see page 4) [2] Bonding Screws FRONT OF CABINET [2] Bottom Screws Provided with kit (with matching cage nuts if needed) (leave slightly extended) Adjust Switch Ducting -Use [4] wing nuts and tooth washers to adjust position of switch duct seals -Install foam seal (if necess
PAGE 4
INSTALLATION INSTRUCTIONS V00029ER Routing of Switch Power Cable -Route switch power cable through power grommet (located on either side of DIFBA2002S00S) -Use utility knife to slit power grommet(s) along guide lines, as needed, to allow for power cord pass-through Switch Power Cable Slit Power Grommet(s) to allow for power cord pass-through (use utility knife) [2] Power Grommets Install Front Perforated Plate -Slide slots at bottom of Front Perforated Plate over [2] bottom screws -Secure top of Front