Multilayer Switch Started Guide Catalyst 3550

Connect to 100BASE-FX Ports

Follow these steps:

Install and Connect to GBIC Module Ports

Follow these steps:

For a list of supported modules, refer to the release notes on Cisco.com. For detailed instructions on

installing and removing modules, refer to the documentation that came with the GBIC module.

Step 1

Remove the dust plugs from the

100BASE-FX ports and the rubber

caps from the MT-RJ patch cable.

Store them for future use.

Step 2

Insert an appropriate cable into a 100BASE-FX port. Insert the other cable end into an SC

or ST port on the other device.

Step 1

Grasp the module on the sides, and

insert it into the switch slot until you

feel the connector snap into place.

Step 2

Insert an appropriate cable into the

moduleport.Insertthe other cable end

into the other device.

MODE

SYSTEM

RPS

STATUS

UTIL

DUPLX

SPEED

1X 2X 3X 4X 5X 6X 7X 8X

100BASE-FX ports

GBIC module

234

910

GBIC module port

234

910