User Manual
1514
USER MANUAL
PANDORA MINI V4 CAR SERVICESECURITY SYSTEM
IV. EXIT THE PROGRAMMING MODE
To finish the pairing procedure, exit the programming mode - switch on
the ignition and then switch it off.
NOTE! IF A MOBILE DEVICE HAS BEEN ALREADY PAIRED, IT WILL BE DELETED WHEN
YOU ENTER THIS LEVEL. WHEN YOU OVERWRITE THE SAME DEVICE IN THE SYSTEM MEM-
ORY, YOU SHOULD DELETE THE BLUETOOTH CONNECTION ON YOUR MOBILE DEVICE.
NOTE! IF THERE IS NO AUTOMATIC PAIRING, ENABLE THE “PIN REQUEST FOR PHONE PAIR-
ING” ITEM IN THE “RADIO TAG AND MOBILE DEVICE FUNCTIONS” SETTINGS AND MAKE THE
PAIRING PROCEDURE AGAIN. A MOBILE DEVICE WILL REQUEST A PIN-CODE (FACTORY PRE-
SET IS 0-0-1-1-1-1 WHERE 4 LAST DIGITS ARE THE “SERVICE PIN-CODE”.
Using the application
Run the application when you are near the system in the Bluetooth radio range.
The application will automatically detect your system and will open the main
screen with the connected system.
NOTE! THE PAIRED MOBILE DEVICE CAN BE USED AS AN OWNER AUTHORIZATION DEVICE
FOR THE “IMMOBILIZER”, “ANTIHIJACK”, “HANDSFREE” MODES. IT IS REQUIRED TO MAKE
ADDITIONAL SET TINGS TO ACTIVATE THIS FUNCTION.
The main screen contains the following infor-
mation and functions:
I
EVENT HISTORY - provides access to event
II
VEHICLE – displays current status informa-
tion about the vehicle and system.
NOTE! IF YOU WANT TO CHANGE VEHICLE T YPE OR AP-
PLICATION THEME, GO TO SETTINGS->APP->CONTROL
System modes:
System is armed System is
disarmed
Service mode is enabled System is in programming mode
Vehicle and system statuses:
1
Doors
2
Front hood
3
Trunk
Ignition
Brake pedal
Engine is running
Interior/engine temperature
Shock sensor
Tilt sensor
Motion sensor
Additional sensor
On-board voltage
Fuel level
Outside temperature
13:51 Armed
In slave mode
13:50 Disarmed
In slave mode
13:50 Armed
with remote
13:50 Alarm
passenger door
13:49 Disarmed
with remote
SIM
12,5V
78°
40%
36°
20:22
My car
20 oct. 20:22 • Armed
18°
I
I
II
III