Daim Ntawv Qhia Tus Neeg Siv

USER AND INSTALLATION MANUALPANDORA MINI MOTO

Updating rmware of the tag

• Download the Pandora BT application (Android / iOS) or Pandora Specialist (Android) on the devices

equipped with a Bluetooth 4.0 Low Energy or higher module.

• Open the mobile app, find the system.

• Press and hold the button

of the radio tag until the 10th flash of the «SEND» indicator, then

release the button.

• Select the found device and select one of the update options: FILE MANAGER – firmware will be

uploaded from the phone storage (only for Android). INTERNET – firmware will be uploaded by an

internet connection.

MOBILE APPLICATION

Pandora Connect is a mobile application to control the system, receive status information and use

the mobile phone as an authorization device on a distance of a Bluetooth connection. The mobile

phone must be paired with the system.

The Pandora Connect mobile app is available for

downloading from the corresponding app store:

App Store for iOS devices;

Google Play for Android devices.

Read the procedure for writing a mobile device to the

system memory:

I. ENTER THE PROGRAMMING MODE

Use the VALET button to enter the «Service PIN-code» (default value is 1-1-1-1). See the detailed

instruction of code entering in the «Control over the system in case of emergency» section.

II. ENTER THE «PAIRING A MOBILE PHONE» PROGRAMMING LEVEL

After entering programming mode, press and hold the VALET button for 5 seconds (until the fifth

signal of the Siren). The system will enter the «Pairing a mobile phone» programming level. The LED

indicator will light green, the system is ready for pairing.

III. PAIR A MOBILE DEVICE

Enable the Bluetooth connection in the mobile device, enter the app settings, click «Bluetooth

control», click «Not defined». In the search box, establish a connection with the detected system. The

red and green flashes of the «LED» indicator light and a single siren sound will confirm the pairing.

IV. EXIT PROGRAMMING MODE

Turn on the ignition and then turn off to exit programming mode.

ThE maNufacTurEr rEsErvEs ThE righT TO makE chaNgEs Of ThE iNTErfacE aNd fuNcTiONaliTy Of ThE iNTErNET sErvicE aNd

mObilE applicaTiON wiThOuT NOTifyiNg ThE cONsumEr.

ThE sysTEm suppOrTs bluETOOTh cONNEcTiON ONly wiTh ONE mObilE dEvicE.

fTEr pairiNg Of a NEw dEvicE ThE prEviOusly pairEd will bE ErasEd frOm ThE sysTEm mEmOry.

hEN pairiNg ThE prEviOusly pairEd dEvicE firsT dElETE ThE ExisTiNg bluETOOTh cONNEcTiON iN ThE mObilE phONE, ThEN

makE a pairiNg ONcE agaiN.

f ThErE is NO auTOmaTic pairiNg, ENablE ThE «piN rEquEsT fOr phONE pairiNg» iTEm iN ThE «radiO Tag aNd mObilE dEvicE

fuNcTiONs

» sETTiNgs aNd makE ThE pairiNg prOcEdurE agaiN. a mObilE dEvicE will rEquEsT a piN-cOdE (facTOry prE-sET

0-0-1-1-1-1 whErE 4 lasT digiTs arE ThE «sErvicE piN-cOdE». This sETTiNg shOuld bE madE by a qualifiEd TEchNiciaN.