User's Manual

User’s Manual Wireless USB Adapter
1
Federal Communication Commission Int erference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
1. Introduction
Thank you for purchasing the IEEE 802.11b/g or 802.11n Wireless USB Adapter. This Wireless Adapter
is easy to use and easy to setup. If you have been tired of dealing with all those messy wires to connect
a laptop or PC to office or home network, this Wireless adapter is an ideal access solution for wireless
Internet connection.
A typical Internet access application for the USB wireless adapter is shown as the following figure:
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This device
and its antenna must not be located or operating in conjunction with any other antenna or transmitter. The device has
been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition
without restriction.
Note: WiFi 802.11a is only for indoor use.
The SAR limit adopted by USA and Canada is 1.6 watts/kilogram (W/kg) averaged over one gram of tissue. The
highest SAR value reported to the FCC and IC for this device type
when properly worn on the body is 0.774 W/kg.
RF exposure information:This product is compliance to FCC RF exposure requirements and refer to FCC website
seach for FCC ID:2ADUTLGPAU07 to gain furture information include SAR Values.