Owner's Manual
SUCTION
CUP
MOUNT
INSTALLATION INSTRUCTIONS:
1. Thoroughly clean
the
smooth
, flat, non-porous
mounting
surface
(windshield,
window.
mirror,
etc.).
The
surface should
be
dry
and
free
of
any scratches.
2. Loosen
the
Arm Adjusting Knob so
the
Mounting
Arm
moves up and
down
.
3.
Position
the
Suction Cup Locking Lever
in
the "
down
" position.
4.
Position the Suction Cup
in
your mounting
area
.
In
order
to
remove
the
mount
easily,
PanaVise
recommends that the Suction Cup
Release
Tab
be at the
bottom
of
the installation and
that
the Mounting Arm
moves
freely
in
a vertical line.
5.
Push
the
Suction Cup
firmly
against
the
mounting
surface
(the Suction
Cup Lever should
be
in
the
"down"position).
Press
the
Suction Cup
Button
and
pull
the
Suction Cup Locking Lever up and
over
the
Button.
You
will
feel
the
Button move
out
during this
procedure; this
action
locks
the
Suction Cup
into
place.
6.
Lift
the
Telescoping Arm Latch so
the
arm
will
move in and
out
.
7.
Telescope
the
arm
to
the
desired length. Once set, push
the
Telescoping
Arm
Latch
down to set the length.
8.
Move
the
arm up and
down
to
the
desired
position
and
lock
into
place
with
the
arm Adjusting Knob.
9. Loosen
the
Adjusting Knob,
position
the
PortaGRIP,
then tighten
the Adjusting Knob.
1:)
. Installation
is
complete.
11.
To
release
the
Suction Cup, move
the
Suction Cup Locking Lever
back
into
its "
down
" position.
Lift
the
Suction Cup Release Tab
to
help break
the
hold.
HOW
TO
PLACE
YOUR MOBILE DEVICE
1.
To
open PortaGRIP arms, press
the
release button
found
on
the
lower
left
side
of
the
phone holder.
2
To
secure your mobile device, place the device
in
the gripper and
squeeze the
arms
closed. Move
the
feet and vertical grips
to
custom
fit
your device.
Release
Tab
Includes:
PortaGRIP
&
709B
Telescoping Suction
Cup
Mount
Tools Needed: None
Adjusting
Knobs
&
Latches
PanaVise Products, Inc. •
7540
Colbert
Drive
• Reno,
NV
89511 •
www.panavise.com
•
800.759.7535