Camera Drive Unit WV-PS11B Before attempting to connect or operate this product, please read these instructions completely.
ENGLISH VERSION CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK), NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is interned to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
Caution: Before attempting to connect or operate this product, please read the label on the bottom. For U.K. IMPORTANT The wires in this mains lead are coloured in accordance with the following code. Green-and-yellow: Earth Blue: Neutral Brown: Live As the colours of the wire in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows.
CONTENTS PREFACE PREFACE ..................................................................... 2 FEATURES ................................................................... 2 PRECAUTIONS ............................................................ 3 MAJOR OPERATING COMPONENTS AND THEIR FUNCTIONS ............................................. 4 CONNECTIONS ........................................................... 5 SPECIFICATIONS ........................................................
PRECAUTIONS • Do not drop any metallic parts through slots. This action could damage the appliance permanently. Turn the power off immediately and refer servicing to qualified service personnel. • Use the appliance under conditions where temperatures are within –10°C - +50°C (14°F - 122°F), and humidity is below 90%. The input power source is 220 - 240V AC 50 Hz. Do not operate the appliance in an extreme environment where is out of its specified temperature or humidity range, or power source ratings.
MAJOR OPERATING COMPONENTS AND THEIR FUNCTIONS POWER CAMERA IN VIDEO OUT AUDIO OUT VD/SYNC IN VD/SYNC OUT ON OFF CAUTION USE WITH SPECIFIED EQUIPMENT SEE ITS MANUAL BEFORE CONECTING. SIGNAL GND r Audio Output Connector (AUDIO OUT) The audio signal of the specified camera is provided at this connector for input into the video monitor (used with the WV-CF20 or WV-CP100 camera.).
CONNECTIONS Cautions: • Set the POWER switch of the camera drive unit to OFF (l) during connections. If the power of the camera drive unit is ON during connections, the protection circuit that protects it in case of wrong connection will operate and prevent the camera from functioning. • Connect only a specified camera, WV-BP70, WV-CF20 or WV-CP100. If another camera is connected, the camera drive unit will not operate due to activation of the protection circuit.
Monitor 1 2 3 4 5 6 Camera Drive Unit WV-PS11B CAMERA IN CAMERA IN VIDEO OUT AUDIO OUT VD/SYNC IN VD/SYNC OUT SIGNAL GND TL VIDEO OUT VTR Camera VD/SYNC CAMERA IN Monitor CAMERA IN VIDEO OUT AUDIO OUT VD/SYNC IN VD/SYNC OUT SIGNAL GND Camera Drive Unit WV-PS11B VIDEO OUT Camera -6-
1. Connect the coaxial cable between the camera and CAMERA IN connector of the camera drive unit. The approximate maximum cable length is as follows: Coaxial Cable Type DC R/1000 ft. of Inner Conductor Maximum Cable Length RG-59/U RG-6/U Less than 30 Ω Less than 12 Ω 200 m (660 ft.) 500 m (1,650 ft.
• Composite Sync: 4 V[p-p] /75 Ω Relation between VD/SYNC IN and VD/SYNC OUT The signal from the VD/SYNC OUT connector differs according to the connected camera and the signal supplied to the VD/SYNC IN connector of this unit. The signal supplied from VD/SYNC OUT is as folllows: • VS: 1 V[p-p] /75 Ω Accuracy of vertical signal Vertical frequency: 50 Hz ± 0.
SPECIFICATIONS Power Source: Power Consumption: Camera Input: Video Output: Audio Output: Camera Power Supply: Maximum Distance to Camera: 220 - 240 V AC 50 Hz Approx. 16 W 1.0 V[p-p] / 75 Ω, BNC Connector 1.0 V[p-p] / 75 Ω, BNC Connector –10 dB / 600 Ω unbalanced, RCA pin jack Regulated current multiplex method (310 mA) Coaxial DC R/1000 ft.
Matsushita Electric Industrial Co., Ltd. Central P.O.
