User Guide

ON
OFF
POWER
SEQUENCE 1 2 3 4
SET UP
PUSH
Video Monitor WV-CM 143
CAMERA
EXT
INPUT
SELECT
ON
STAND BY
MODE
V-HOLD
COLOR BRIGHT CONTRAST PICTURE AUDIO
.MAXMIN.
COLOR
TINT
-2-
MAJOR OPERATING CONTROLS AND THEIR FUNCTIONS
■ FRONT VIEW
q
w
e
r
t
y
u
i
o
!0
!1
!2
!3
!4
!5
!6
!7
!8
1 2 3 4
INPUT SELECT
VIDEO Y/C
PAL
POWER
ON
OFF
NTSC
(3.58)
M.NTSC
(4.43)
6. Colour Control (COLOUR)
Turn this control clockwise to increase the picture
colour and turn this control counterclockwise to
decrease the picture colour.
7. Colour Subcontrol
8. Bright Control (BRIGHT)
Turn this control clockwise to increase the picture
brightness and turn this control counterclockwise to
decrease the picture brightness.
5. Vertical Hold Control (V-HOLD)
This control is used to adjust the picture in vertically.
1. Power Switch (POWER)
This is a push-push type switch which turns the power
of the monitor on and off.
Press once and the switch remains down (
) for turn-
ing on the power of monitor.
Press again, the switch comes up (
) for turning off
the power of the monitor.
2. Power Indicator
3. Mode Selection Switch (STAND BY
/ ON )
ON: The picture of the camera will appear on the moni-
tor.
STAND BY: The picture of the camera will not appear
on the monitor in the sequence mode, however the
picture can be observed at Video Output
Connector (26).
4. Input Selection Switch (EXT(
) CAMERA( )
This selects the picture displayed on the monitor as ;
EXT: VTR playback picture which connected to Video
Input Connector(25) can be observed.
CAMERA: Camera picture which is connected to
Camera Input Connectors (27) can be observed.