User Guide

-7-
** SET UP MENU **
CAMERA ID 1 2 3 4
1 CAMERA
AUDIO SELECT SEQ
TIMING SELECT INT
SEQ TIME ADJ 1 SEC
ALARM BUZZER ON
ALARM TIME ADJ 60 SEC
AUTO RESET ON
BRIGHT COMP 1 2 3 4
END SET UP DISABLE
2. SETUP ORDER
When the camera setup is required, proceed it according
to the following steps.
(1) Display the SETUP menu.
(2) Camera Identification setting
(3) Audio Selection
(4) Timing Selection
(5) Sequential Time Adjustment
(6) Alarm Sound On/Off Setting
(7) Alarm Time Adjustment
(8) Automatic Reset Setting
(9) Bright Compensation setting
3-2. Audio Selection (AUDIO SELECT)
** SET UP MENU **
CAMERA ID 1 2 3 4
1 CAMERA
AUDIO SELECT SEQ
TIMING SELECT INT
SEQ TIME ADJ 1 SEC
ALARM BUZZER ON
ALARM TIME ADJ 60 SEC
AUTO RESET ON
BRIGHT COMP 1 2 3 4
END SET UP DISABLE
1. SETUP MENU
This monitor utilizes various user setup menu by using the on-screen character display.
This setup menu is shown in the following.
This menu is described in the following section 3 “SETUP MENU DESCRIPTION” in detail.
A setup operations performed by the following switches on
the front panel.
SEQUENCE 1 2 3 4
SET UP
Up Switch : The cursor moves upwards.
Down Switch : The cursor moves downwards.
Right Switch : The cursor moves right. The mode is
selected by this switch.
The adjustment of certain levels can be
made by this switch.
Left Switch : The cursor moves left. The mode is select-
ed by this switch. The adjustment of cer-
tain levels can be made by this switch.
Setup Switch : The mode is set this switch. The menu is
changed by this switch.
Right Switch (18)
Left Switch (17)
Setup Switch
(14)
Down Switch (16)
Up Switch (15)
SET UP menu
Camera
ID
ON/OFF
Audio
Select
Timing
Select
Auto
Reset
Sequence
Time
Adjust
Alarm
Time
Adjust
SETUP DISABLE → SETUP ENABLE →
Alarm
Buzzer
ON/OFF
Bright
Compensation
ON/OFF
3. SETUP MENU DESCRIPTION
3-1. Camera Identification (CAMERA ID)
Up to 8 of alphabetic/number characters for camera
identification characters can be displayed on the top
line of the picture.
The ID display On or Off can be set on the first line of
this item and the editing of displayed characters can
be made in the second line.
Note: Refer to the SETUP OPERATION section for
detailed procedure.
Select the audio signal from SEQ or SPOT (1, 2, 3, 4).