User Guide

-8-
The selected full or Half Duplex Setting will become
valid after the camera has been powered up again.
!4 Gen-lock Input Connector (GEN-LOCK)
This connector is used to connect an external sys-
tem for synchronization.
!5 Video Output Connector (VIDEO OUT)
This connector is used to connect with the VIDEO
IN connector of the monitor.
!6 RS485 Terminals
(RS485, T(A)/T(B)/R(A)/R(B)/GND)
These terminals are used for RS-485 site communi-
cation. Connect RS-485 cables to these terminals.
!7 AC Inlet Socket
Plug the power cord (supplied as a standard
accessory) into this socket and connect it to an AC
outlet.
!8 AC/DC Compatible Input Terminal
(DC 12V IN/AC 24V IN)
This terminal is for connecting the 12 V DC or 24 V
AC power supply cord.
Caution: Connect to 12 V DC (10.8 V-16 V) or 24 V
AC (19.5 V-28 V) class 2 power supply only.
Make sure to connect the grounding lead to the
GND terminal when the power is supplied from a
24 V AC power source.