User Guide

ManualsBrandsPanasonic ManualsSecurity CameraWV-CL830

-30-

4. After confirming the cursor is on EXT (VS), press

. The phase adjustment menu appears on the

monitor.

6-2. VS Gen-lock Mode (EXT(VS))

1. Move the cursor to the SYNC parameter and

select INT.

2. Connect the coaxial cable for the composite sync

or composite B/W video signal to the gen-lock

input connector.

3. Confirm that the parameter INT changed to EXT

(VS) on the menu.

Caution: The gen-lock input signal should meet

with CCIR specifications and should not con-

tain jitter, such as a VTR playback signal , as

it could disturb synchronization.

5. Move the cursor to H PHASE. The cursor starts

blinking.

6. Supply the video output signal of the camera to be

adjusted and the reference gen-lock input signal

to a dual-trace oscilloscope.

7. Set the oscilloscope to the horizontal rate and

expand the horizontal sync portion on the oscillo-

scope.

8. Adjust the horizontal phase by pressing or

. The adjustable range is 0 - 2.0µs.

6-3. Line-lock Sync Mode (LL)

Note: The line-lock (LL) sync mode is not available

when the camera operates on DC power.

1. Move the cursor to the SYNC parameter and

select LL.

Note: The settings in this menu can be made only

when the multiplexed vertical drive signal

(VD2) is not supplied to the camera.

** CAM SET UP **

CAMERA ID OFF

ALC/ELC ALC

SHUTTER OFF

AGC ON

SENS UP OFF

SYNC INT

WHITE BAL ATW

MOTION DET OFF

LENS DRIVE DC

END SET UP ENABLE

↵↵↵↵