Operating Instructions

42
43
Step 5
Enter the password, and then click the [Next] button.
For character entry, refer to "About the operation of
on-screen keyboard" (
☞ page 16).
 • Enter5to8alphanumericcharactersforapass-
word.
 • Toconfirmthepassword,enterthesamepass-
word again into the "Confirm" column.
 • Tosavetheenteredpassword,check"Memorize
password temporarily". The next time data is cop-
ied, the password entry window will open with the
password already filled in. The password will be
retained in memory until the power of the recorder
is turned off
→ The copy start confirmation window will be dis-
played.
Step 6
Click the [OK] button in the copy start confirmation
window.
→ "Copying" is displayed in the status display area,
and copying will start. When copying is complet-
ed, "Copying" will go off.
Important:
 • DonotremovetheSDmemorycardduringcopy-
ing data onto the SD memory card. Otherwise the
data stored on the SD memory card could be lost.
 • Ifthecopydestinationlackssufficientremaining
storage capacity, copying will continue until the
medium is full. Use a medium with sufficient stor-
age capacity to avoid left over data that is not
copied.
 • Copyingwillbeperformedinthefollowingorder:
Viewer Software → Images → Audio Depending
on the designated time range for copying and the
remaining space of the storage medium, images
and audio may not be copied.
 • Clickingthe[Copy]buttonduringthecopyingpro-
cess will display the copy cancel confirmation
window, allowing you to cancel copying. Copying
continues while the copy cancel confirmation win-
dow is displayed.
 • Donotturnoffthepoweroftherecorderwhile
copy is in progress. If the power is turned off while
copying, the storage media copied on will become
unusable.
 • Itispossibletocopyupto10000dataonanSD
memory card and up to 25000 data on a DVD
disc. However, it is impossible to copy any more
data exceeding these limits even when there is a
sufficient remaining capacity.
Step 7
When copying on a DVD disc, a confirmation window
is displayed on completion.
To continue copying, select "Not eject a medium" and
click the [OK] button.
Step 8
After all the required data is copied to the disc, select
"Eject a medium" on the confirmation window and
click the [OK] button.
→ The finalization confirmation window will be dis-
played. When the [OK] button is clicked, finaliza-
tion (the proce-dure to eject the DVD) will be per-
formed. After the procedure is complete, the disc
can be ejected. Press the eject button.
Important:
 • Ifthediscisnotfinalized,thetraymaynotopen
even after the eject button is pressed.
 • IfdataisoncecopiedonaDVDdisc,nomore
copy will be possible after ejection.
 • When"Failedtofinalize."Isdisplayed,thedisc
can be ejected, but cannot be played back. In this
case, retry coping on another disc.
The disc can be ejected as follows instead of step 8.