Operating Instructions

24
25
Live images can be recorded on the recorder. Images from up to 16 cameras can be simultaneously recorded
with this recorder.
Record images (schedule recording)
Recording can be automatically started and stopped according to a previously specified schedule. Refer to the
Installation Guide for schedule recording.
Note:
 • Wheneventrecordingistriggeredbyanalarmduringtheschedulerecording,eventrecordinghasthehigher
priority. Refer to the "Recording mode and its priority" section below for further information about the priori-
ty of the recording mode.
 • Tostopschedulerecording,stoptherecordingonthesetupmenu.RefertotheInstallationGuideforfurther
information.
 • Incaseofanetworkerror,theimageofthecamerawherethecommunicationerrorhasoccurredwillnotbe
recorded. Recording starts when the network error is recovered. If the status in which the communication
with the camera is disconnected recovers within around 40 seconds, images will not be recorded and error
logs will not be saved.
 • Schedule-recordedimagedatawillbedividedintomultiplefileseveryhouronthehour.Inthatmoment,
recording may sometimes be interrupted around for 1 second.
Recording mode and its priority
There are 3 recording modes. The recording modes and their priority levels are as follows.
When two or more recordings with different recording modes started simultaneously, only recording with the
higher priority will start.
Recording mode Priority
Event recording 1
Schedule recording 2
Pre-event recording 3
Record images
Network cameras
HDD
Image data
Recorder