Installation Guide

Set up Light control mode [Light control mode]

Select how to control the amount of light for each camera and transmit the information to the cameras to change the camera

settings. Clicking the [Setup >] button for "Light control mode" on the [Camera setup] tab will display the setup page.

[Light control mode]

Outdoor scene: Depending on the brightness level (illuminance), the iris will automatically be controlled together with the

shutter speed adjustment to control light.

Indoor scene: The shutter speed will automatically be adjusted to prevent flicker caused by fluorescent light. (For the 50 Hz

areas)

Indoor scene(60 Hz): The shutter speed will automatically be adjusted to prevent flicker caused by fluorescent light. (For the

60 Hz areas)

Default: Indoor scene

Note:

 • When"Outdoorscene"isselected,flickermayoccurwhenasubjectisunderfluorescentlighting.

Set up 360 pan-flip [360 pan-flip]

Select the 360 pan-flip function for each camera and transmit the information to the cameras to change the camera settings.

Clicking the [Setup >] button for "360 pan-flip" on the [Camera setup] tab will display the setup page.

[360 pan-flip]

Select whether or not to activate the 360 pan-flip function that can achieve camera controllability equal to 360° endless cameras.

On: The 360 pan-flip function will work.

Off: The 360 pan-flip function will not work.

Default: Off

Set up the method of camera installation [Upside-down]

Select the method of camera installation for each camera and transmit the information to the cameras to change the camera set-

tings. Clicking the [Setup >] button for " Upside-down " on the [Camera setup] tab will display the setup window.

[Upside-down]

On (desktop): Select this when the camera is to be installed with the dome side up.

Off (ceiling): Select this when the camera is to be installed with the dome side down.

Default: On (desktop)

Set up Max bit rate [Max bit rate (per client)]

Select the bit rate per a client when the compression method of the camera is MJPEG or H.264 for each camera and transmit

the information to the cameras to change the camera settings. Clicking the [Setup >] button for " Max bit rate (per client) " on the

[Camera setup] tab will display the setup page.

[Max bit rate (per client)]

64 kbps/ 128 kbps/ 256 kbps/ 384 kbps/ 512 kbps/ 768 kbps/ 1024 kbps/ 1536 kbps/ 2048 kbps/ 3072 kbps/ 4096 kbps

Default: 1024 kbps

Set up how to turn on or off the indicators [Indicator]

Select how to turn on or off the link indicator, access indicator or status indicators for each camera and transmit the information

to the cameras to change the camera settings. Clicking the [Setup >] button for "Indicator" on the [Camera setup] tab will display

the setup page.

[Indicator]

On: All the indicators will light in accordance with the status.

On(Access): Only the live indicator will light when images are viewed.

Off: All the indicators will light off.

Default: Off

Note:

 • Refertopage49 for further information about "Camera Selection", the [Transmission] button and the [Back] button.