Installation Guide

Turn on the power of the recorder

Turn on the power of the recorder. When using the recorder for the first time, register the license for the recorder. (☞ Page 34)

Step 1

Turn on the recorder

Connect the provided power cord to the power cord inlet on

the rear panel of the recorder, and insert the power plug to

an outlet. Be sure to use the following power source.

WJ-NV200K, WJ-NV200VK: 120 V AC, 60 Hz

WJ-NV200K/G: 220 V - 240 V AC, 50 Hz/60 Hz

→ The [OPERATE] indicator will light, the system check of

the recorder and the hard disk drives will start, and the

startup window will be displayed on the main monitor.

Important:

 • Neverturnoffthepoweroftherecorderduringstartup.

Note:

 • Ifthelicensefortherecorderhasnotbeenregistered

yet, the message asking you to register the "Registration

Key" will be displayed.

Step 2

If the "Registration Key" for the recorder has not been regis-

tered yet, register the "Registration Key" by following the

procedures on page 34.

Note:

 • Whenthe"Login"windowisdisplayedduringoperation

after startup, enter the user name and password. Refer

to the Operating Instructions (PDF) for descriptions of

how to operate.

 • Ifthe"RegistrationKey"fortherecorderisonceregis-

tered, the message asking you to register the

"Registration Key" will not be displayed from the next

time.