Installation Guide

30
Before installing the hard disk drives, turn off the power of this recorder first. When replacing the hard disk drives, the procedures
will be same as those of installation. When installing or replacing the hard disk drives for playback use only (hard disk drives that
are formerly used for recording), perform the link process.
Important:
 • WhensecuringtheharddiskdrivestotheHDDbrackets,donotmistakethedirectionoftheconnectors.(Donotinstallthe
hard disk drives in the opposite direction.)
 • Wheninstallingharddiskdrives,usealow-torquepoweredscrewdriveroratorquescrewdrivertotightenscrewswiththe
specified torque.
 • Harddiskdrivesareprecisedevices.Handlewithcarewhilekeepingthefollowinginmind.
 • Donotsubjecttheharddiskdrivetoanyvibrationorimpact.
 • Beforetouchingtheharddiskdrive,eliminatestaticelectricitybytouchingasteellocker,etc.Whenholdingtheharddisk
drive, hold the both sides of the hard disk drive.
 • Donottouchthecircuitboardortheconnectorstopreventtheharddiskdrivefromdamagingbystaticelectricity.
 • Contactyourdealerforharddiskdrivesthatworksontherecorder.Pleasebeforewarnedthatoperationwithanyharddisk
drive other than the specified models is not guaranteed under any circumstances.
 • Whenusingmultipleharddiskdrives,usethesamemodel.
If different models are used together, even when the capacities of them are the same, the available capacity may be a few
percent smaller.
Note:
 • Harddiskdrivesarelocallyprocured.Contactyourdealerforpurchasing,installing,andreplacingtheharddiskdrives.
Install the hard disk drives
Installation or replacement of the hard disk drives
Step 1
Turn off the power of the recorder. (☞ Page 33)
Step 2
Remove the HDD bracket screws (x2) on the HDD slots on
the rear panel of the recorder, and pull out the HDD bracket.
Note:
 • WJ-NV200VKisequippedwithonlyanHDDslot.
Step 3
Install the hard disk drive into the HDD bracket using 4 HDD
fixing screws (accessories).
Tightening torque for the screws: 0.49 N·m {0.36 lbf·ft}
HDD1
HDD2
SIGNAL GND
AC IN
ALARM/CONTROL
AV OUT
10/100/1000
BASE-T
SPOT OUT
AUDIO OUT
HDD bracket screw
HDD fixing screw (accessory)
HDD fixing screw (accessory)