Installation Guide

ManualsBrandsPanasonic ManualsDVD-playersWJ-ND400

New functions (Software V3.40)

Due to software upgrade, the following new functions have become available.

Details on the new functions Reference pages

It is possible to start obtaining SD memory data (images recorded on the SD

memory card on the camera) manually.

When the SD memory backup is activated, the [Obtain SD memory data]

button will be displayed under the [Stop recording] button. Obtaining SD

memory data will start when the [Obtain SD memory data] button is clicked.

Operating Instructions

page 16

The event log relating to the i-VMD of the camera is added.

CAM-INT: Intruder detection

CAM-LOI: Loitering detection

CAM-DIR: Direction detection

CAM-SCD: Scene change detection

 This function is available when “On” is selected for “Additional alarm

area data” on the camera. For further information about this setting,

refer to the operating instructions of the camera in use.

Operating Instructions

page 42

Note:

Summary of content (5 pages)

PAGE 1
New functions (Software V3.40) Due to software upgrade, the following new functions have become available. Details on the new functions Reference pages It is possible to start obtaining SD memory data (images recorded on the SD memory card on the camera) manually. When the SD memory backup is activated, the [Obtain SD memory data] button will be displayed under the [Stop recording] button. Obtaining SD memory data will start when the [Obtain SD memory data] button is clicked.
PAGE 2
Details on the new functions Reference pages By using the viewer software, the function that compensates and converts fish-eye images captured by Panasonic's 360-degree network camera (hereinafter referred to as 360-degree camera) to "1-screen PTZ" or "4-screen PTZ" is now available.(Compensation function) Important: The compensation function is available only when the library file for compensation is downloaded from the URL below and installed on the PC in which the viewer software is installed.
PAGE 3
New functions (Software V3.30) Due to software upgrade, the following new functions have become available. Details on the new functions Menu to configure the settings The setting of SD memory recording has become available even when the compression method is “H.264”. [Emergency rec.] [Schedule] > [Program] SD memory recording Off*/On → Setup Instructions, page 36: “SD memory rec.” * Default when cameras have been registered (Compression: H.264) Note:  When setting the SD memory recording in H.
PAGE 4
Details on the new functions Menu to configure the settings The following two NTP server addresses can be registered.
PAGE 5
New functions (Software V3.20) Due to software upgrade, the following new functions have become available. Details on the new functions ONVIF compliant cameras can be used with the recorder. Menu to configure the settings [Camera] > [NW camera] Note:  For further information, refer to the "readme.txt" on the provided CD-ROM. The underlined setting values are added to “Hour meter warning”.