Operating instructions

A
A
E
D
71.5 mm
56 mmB
C
A Mounting base
B LAN cable
C DC cable from power supply unit
D Area c
aulked with water-resistant sealant
E A
rea not to be caulked
3 C
onnect the wires and cables to the door
s
tation.
R See “Connecting the wires and cables”,
Page 14.
4 Attach the door station to the mounting base,
and then secure the door station to the
mounting base using the screw.
Connecting the wires and cables
1 Co
nnect the LAN cable to the LAN connector.
2 Optional
If you are using a power supply unit to power
the door station, connect the DC plug to the
DC IN connector.
R See “Installing the power supply unit (sold
separately)”, Page 10 for information about
installing the power supply unit.
3 Optional
If you are using a relay box to connect an
electric lock to the door station, insert the
wires from the relay box into the 2-pin terminal
block, tighten the terminal block screws, and
then attach the 2-pin terminal block to
connection terminals R1 and R2.
R Make sure the wires are inserted fully into
the terminal block and that the terminal
block screws are tight enough to prevent
the wires from pulling out.
R Make sure the 2-pin terminal block snaps
into place and is securely connected to
connection terminals R1 and R2.
R See “Installing the relay box (sold
separately)”, Page 15 for information
about installing the relay box.
A
C
D
B
A LAN cable
B DC plug from power supply unit
C 2-pin terminal block
D Wires from relay box
14
Installation