Operating Instructions

2.3 Features available when talking on a doorphone call or monitoring

2.3.1 Switching the display orientation

Tap the display orientation button (A) in the image viewing area, or rotate your mobile device so that it is in landscape

position (i.e., parallel to the ground) or portrait position (i.e., perpendicular to the ground).

Note:

R When you switch to landscape display mode, the operation buttons disappear and only the image display area is

shown. In order to call a doorphone or perform certain operations, you must switch to portrait display mode.

R The ability to switching between portrait and landscape display modes by rotating your mobile device may not be

available depending on the features of your mobile device.

2.3.2 Zoom, pan, and tilt

Zooming in and out (wide mode, zoom mode)

Double tap the displayed image to zoom in (zoom mode); double tap again to zoom out (wide mode).

Changing the area that is displayed (pan/tilt)

While using zoom mode, tap the desired area of the image.

2.3.3 Backlight compensation, lighting, and speaker settings

The following features are not available when using landscape display mode.

Configuring backlight compensation for the doorphone

Configure settings when an image is displayed or when talking on a doorphone call.

1. From the [Video Intercom] app’s operation screen, tap ® [Backlight compensation].

2. Tap [-] or [+] to adjust brightness.

R Adjust the brightness while checking the displayed image.

R To turn off backlight compensation, tap [OFF].

R Depending on the doorphone you are using, the adjustment buttons may be displayed as [OFF] and [ON].

Turning the doorphone’s LED lights on and off

Configure settings when an image is displayed or when talking on a doorphone call.

1. From the [Video Intercom] app’s operation screen, tap ® [Illumination].

2. Select [ON] or [OFF], and then tap [OK].

Changing the audio output

While talking on a doorphone call or monitoring, you can switch between the available audio outputs.

1. From the [Video Intercom] app’s operation screen, tap ® [Speaker].

2. Select the desired setting.

R Available settings vary by your mobile device’s settings, hardware configuration, etc.

R This setting is used only for the current doorphone call or monitoring session. The next time you answer a

doorphone call or start monitoring, the audio output selected for the [Speaker setting] setting will be used.

You can change this setting in the setting menu (page 15).

2. Using the app