Operating Instructions

- 57 -
Manual Tuning
●
Normally use Auto Setup or Update Channel List to retune DVB channels.
●
If tuning has not been done completely or for adjusting the direction of the
aerial, use this function. (DVB)
●
All DVB channels found will be added to Channel List.
■ DVB-C
1. Enter the frequency with numeric buttons
●
Normally set Symbol Rate and Service ID to Auto.
2. Select Start scan with
/ and press OK to search
■ DVB-T
1. Select a channel with / and adjust frequency with / for each
channel
●
Set where the level of Signal Quality becomes the maximum.
2. Press OK to search
■ Analogue
Set Analogue channel manually after Auto Setup.
1. Select the channel position with numeric buttons
2. Select the channel with Channel Up / Down button
3. Search with /
4. Select Store with / and press OK to set
●
Use Fine Tuning to make small adjustments to the tuning of an individual
programme (affected by weather conditions, etc.).
●
If a VCR is connected only with the RF cable, select channel position 0.