OPERATING INSTRUCTIONS TX-43MX600B TX-50MX600B TX-55MX600B TX-65MX600B LED TV e-MANUAL You can find instructions for your TV’s features in the E-Manual. To access the E-Manual, enter Settings menu, select Manuals and press OK. For quick access press Home/Menu button and then Info button.
Contents Safety Information.................................................... 2 Markings on the Product.......................................... 2 Assembling / Removing the pedestal....................... 4 When using the wall-hanging bracket...................... 4 Environmental Information....................................... 5 Features................................................................... 5 Accessories Included............................................... 5 TV Control & Operation.....
• Do not place any heat sources such as electric heaters, radiators, etc. near the TV set. Safety Information • Do not place the TV on the floor or inclined surfaces. CAUTION • To avoid danger of suffocation, keep plastic bags out of the reach of babies, children and domestic animals. RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
WARNING • Do not ingest the battery, Chemical Burn Hazard. • This product or the accessories supplied with the product may contain a coin/button cell battery. If the coin/button cell battery is swallowed, it can cause severe internal burns in just 2 hours and can lead to death. • Keep new and used batteries away from children. • If the battery compartment does not close securely, stop using the product and keep it away from children.
Removing the pedestal from the TV Assembling / Removing the pedestal Preparations Take out the pedestal(s) and the TV from the packing case and put the TV onto a work table with the screen panel down on the clean and soft cloth (blanket, etc.) • Use a flat and firm table bigger than the TV. • Do not hold the screen panel part. • Put the TV onto a work table with the screen panel down on the clean and soft cloth. Leave the stand(s) protruding over the edge of the surface.
• PLL (Frequency Search) Environmental Information This television is designed to be environmentally friendly. To reduce energy consumption, you can follow these steps: If you set the Energy Saving to Minimum, Medium, Maximum or Auto the TV will adjust the energy consumption accordingly. Set as Off to turn this setting off.
means that the time information is updated, network is connected and sync is successfully completed. Otherwise the icons will appear in white. Depending on the country selection made during first time installation, TV’s life time information in hours can be displayed by pressing the Home button and then the Blue button.
Switching On/Off To Switch the TV On Connect the power cord to a power source such as a wall socket (220-240V AC, 50 Hz). To switch on the TV from standby • Press the Standby button, Programme +/- or a numeric button on the remote control. • Press the centre of the joystick on the TV in or push it up/down. To switch on the TV from hard standby • Press the centre of the joystick on the TV in. To switch the TV into standby Press the Standby button on the remote control, the TV will switch into standby mode.
Important Instruction For your own safety read following instruction carefully before attempting to connect this unit to the mains supply. MAINS (AC) OPERATION The wires in the mains lead are coloured in accordance with the following code : 1 4 2 3 1. Green&Yellow (Earth) (if there is earth cable) 2. Blue (Neutral) 3. Brown (Live) 4.
Specification TV Broadcasting PAL BG/I/DK SECAM BG/DK Receiving Channels VHF (BAND I/III) - UHF (BAND U) - HYPERBAND Digital Reception Fully integrated digital terrestrial-cable-satellite TV (DVB-T-C-S) (DVB-T2, DVB-S2 compliant) Number of Preset Channels 11 000 Channel Indicator On Screen Display RF Aerial Input 75 Ohm (unbalanced) Operating Voltage 220-240V AC, 50Hz. Audio A2 Stereo+Nicam Stereo Headphone 3.
Wireless LAN Transmitter Specifications Frequency Ranges Max Output Power 2400 - 2483.5 MHz (CH1 - CH13) < 100 mW 5150 - 5250 MHz (CH36 - CH48) < 200 mW 5250 - 5350 MHz (CH52 - CH64) < 200 mW 5470 - 5725 MHz (CH100 - CH140) < 200 mW Country Restrictions The Wireless LAN equipment is intended for home and office use in the UK and Northern Ireland (and other countries following the relevant EU and/or UK directive). The 5.15 - 5.
Remote Control 1 25 2 G 1 3 5 6 E 23 HO M 4 24 EXIT 7 8 9 22 BACK 21 20 10 11 12 1. Standby (*): Standby / On (press briefly) Reset / Power Off (press and hold) 2. Info: Displays information about on-screen content, shows hidden information (reveal - in TXT mode) 3. Guide: Displays the electronic programme guide 4. Home: Displays TV menu 5. Directional buttons: Helps navigate menus, content, etc. and displays the subpages in TXT mode when pressed Right or Left 6.
Connectivity Troubleshooting & Tips TV will not turn on Make sure the power cord is plugged in securely to a wall outlet. Press the Standby button on the remote. Poor picture • Check if you have correctly tuned the TV. • Low signal level can cause picture distortion. Please check antenna connections. Wired Connectivity To Connect to a Wired Network • You must have a modem/router connected to an active broadband connection. • Connect your TV to your modem/router via an Ethernet cable.
Network Type Set Network Type as Wired Device if you are connecting via an Ethernet cable. Internet Speed Test Highlight Internet Speed Test and press the OK button. TV will check the internet connection bandwidth and display the result when complete. Advanced Settings and the products that you use. The transmission may also be cut off or may get disconnected depending on the radio wave conditions, DECT phones or any other WLAN 11b appliances.
Press WPS on your wifi router If your router has WPS, you can directly connect to the modem/router without entering a password or adding the network first. Highlight Press WPS on your wifi router option and press OK. Go to your modem/router device and press the WPS button on it to make the connection. You will see a connection confirmation on your TV once the devices have paired. Select OK to proceed. No further configuration is required.
Licence Notification Disposal of Old Equipment and Batteries The terms HDMI, HDMI High-Definition Multimedia Interface, HDMI trade dress and the HDMI Logos are trademarks or registered trademarks of HDMI Licensing Administrator, Inc. Dolby, Dolby Vision, Dolby Atmos, and the double-D symbol are registered trademarks of Dolby Laboratories Licensing Corporation. Manufactured under licence from Dolby Laboratories. Confidential unpublished works. Copyright © 2012-2022 Dolby Laboratories. All rights reserved.
Declaration of Conformity (DoC) Sales and Support Information Hereby, Panasonic Marketing Europe GmbH, declares that this TV is in compliance with the essential requirements and other relevant provisions of the Directive 2014/53/EU. If you want to get a copy of the original DoC of this TV, please visit the following website: http://www.ptc.panasonic.
