Model No. English TX-32ES400B TX-40ES400B TX-49ES400B Operating Instructions LED TV 32-inch model 40-inch model For more detailed instructions, please refer to [eHELP] (Built-in Operating Instructions). 49-inch model ● How to use [eHELP] (p. 18) Thank you for purchasing this Panasonic product. Please read these instructions carefully before operating this product and retain them for future reference. Please carefully read the “Safety Precautions” of this manual before use.
● For information about the trademarks, refer to [eHELP] (Search by Purpose > Read first > Before use > Licence). The illustration for TX-40ES400B is used in this manual unless otherwise mentioned. Illustrations shown may be different depending on the model.
Important Notice This mark shows that the construction of the product is double-insulated. Notice for DVB / Data broadcasting / IPTV functions This TV is designed to meet the standards (as of August, 2016) of digital services. ● Not all the features are available depending on the country, area, broadcaster, service provider and network environment. ● Compatibility with future services is not guaranteed. This mark indicates the product operates under AC voltage. Transport only in upright position.
Safety Precautions ● This TV is designed to operate on AC 220-240 V, 50 / 60 Hz. ● Insert the mains plug fully into the mains socket. To help avoid risk of electrical shock, fire, damage or injury, please follow the warnings and cautions below: ● To turn Off the apparatus completely, you must pull the mains plug out of the mains socket. Consequently, the mains plug should be easily accessible at all times. ■ Mains plug and lead ● Disconnect the mains plug when cleaning the TV.
● If the TV is used in an environment where there is dust or smoke. It is possible for dust/smoke particles to enter the TV through the air vents during normal operation which can become trapped inside the unit. This may cause overheating, malfunction, deterioration in picture quality, etc. ● Do not use an unapproved pedestal / mounting equipment. Be sure to ask your local Panasonic dealer to perform the setup or installation of approved wall-hanging brackets.
● The built-in wireless LAN uses 2.4 GHz and 5 GHz frequency bands. To avoid malfunctions or slow response caused by radio wave interference when using the built-in wireless LAN, keep the TV away from other devices that use 2.4 GHz and 5 GHz signals such as other wireless LAN devices, microwave ovens, and mobile phones. ● When problems occur due to static electricity, etc., the TV might stop operating to protect itself. In this case, turn the TV off at the Mains power On / Off switch, then turn it back on.
Accessories Operating Instructions Production Registration Leaflet ● Accessories may not be placed all together. Take care not to throw them away unintentionally. Standard accessories Assembling / Removing the pedestal Remote Control (p. 14) 32-inch model ● N2QAYB001109 Assembly screw (4) Assembly screw (4) Pedestal 32-inch model M4 × 15 (p. 7) Bracket 40-inch model Base (2) 49-inch model ■ Preparations Mains lead 32-inch model (p.
■ Assembling the pedestal 40-inch model Bracket (R) A R C 1 D Base (L) L B 3 Base (R) R 2 ■ Preparations Take out the pedestal and the TV from the packing case and put the TV onto a work table with the screen panel down on the clean and soft cloth (blanket, etc.). ● Use a flat and firm table bigger than the TV. ● Do not hold the screen panel part. ● Make sure not to scratch or break the TV.
40-inch model 49-inch model ■ Assembling the pedestal 1 ■ Assembling the pedestal A A D 1 C A A C C E E F F 2 L 2 R L R 3 B 3 B English 9
Removing the pedestal from the TV Be sure to remove the pedestal in the following way when using the wall-hanging bracket or repacking the TV. 1 Put the TV onto a work table with the screen panel down on the clean and soft cloth. 2 Remove the assembly screws from the TV. 3 Pull out the pedestal from the TV. 4 Remove the assembly screws from the bracket. Connections ● External equipment and cables shown are not supplied with this TV.
8 ETHERNET terminal (p. 12) AV devices ■ DVD Recorder / Blu-ray Recorder, etc. Basic connections TV ■ Mains lead AC 220-240 V 50 / 60 Hz Mains lead (supplied) Insert the mains plug firmly into place. 32-inch model 40-inch model RF cable HDMI cable DVD Recorder / Blu-ray Recorder, etc. Terrestrial aerial ■ Satellite receiver 49-inch model TV ● When disconnecting the mains lead, be absolutely sure to disconnect the mains plug from the mains socket first.
■ Camcorder / Game equipment Network A broadband network environment is required to be able to use internet services. ● If you do not have any broadband network services, please consult your retailer for assistance. ● Prepare the internet environment for wired connection or wireless connection. ● Setup of the network connection will start when first using the TV. (p.
■ Common Interface ● Turn the TV off with Mains Power On / Off switch whenever inserting or removing the CI module. ● If a smart card and a CI module come as a set, first insert the CI module, then insert the smart card into the CI module. ● Insert or remove the CI module completely in the correct direction as shown. ● Normally encrypted channels will appear. (Viewable channels and their features depend on the CI module.
Identifying Controls 7 OK ● Confirms selections and choices. ● Press after selecting channel positions to quickly change channel. Remote Control 8 [Option Menu] ● Easy optional setting for viewing, sound, etc. 9 Coloured buttons (red-green-yellow-blue) ● Used for the selection, navigation and operation of various functions. 10 Volume Up / Down 11 Numeric buttons ● Changes channel and teletext pages. ● Sets characters. ● When in Standby mode, switches TV on.
■ Installing / Removing batteries Pull open Hook Indicator / Control panel ● When pressing 4, 5, 6 buttons, the control panel guide appears on the right side of the screen for 3 seconds to highlight which button has been pressed. Close 4 5 Note the correct polarity (+ or -) 1 6 2 3 7 Rear side of the TV 1 Remote control signal receiver ● Do not place any objects between the TV remote control signal receiver and remote control.
First time Auto Setup When the TV is turned on for the first time, it will automatically search for available TV channels and give options to set up the TV. ● These steps are not necessary if the setup has been completed by your local dealer. ● Please complete connections (p. 10 - 13) and settings (if necessary) of the connected equipment before starting Auto Setup. For information about the settings for the connected equipment, read the manual of the equipment.
Operations Watching TV 1 1 Turn power on Select the TV viewer from [Home Screen] select (TV) access or (Remote Control) ● Mains power On / Off switch should be on. (p. 15) The last viewed [Home Screen] is displayed. Example: [TV Home Screen] 2 Select the mode ● Selectable modes vary depending on the channels stored. 3 Select a channel up down or Example: Selected content screen ● DVB channel position begins from number 1 upward. Analogue channel position numbers are in the 0 - 99 range.
How to Use eHELP [eHELP] is the detailed operating instructions built into the TV, and gives a more detailed explanation for a better understanding of the operation of each feature.
FAQs Before requesting service or assistance, please follow these simple guides to solve the problem. ● For details, refer to [eHELP] (Support > FAQs). The TV does not switch on ● Check the mains lead is plugged into the TV and the mains socket. ● The fuse in the mains plug may have blown. Replace it with one of an identical rating. (p. 4) The TV goes into Standby mode ● Auto power standby function is activated. The remote control does not work or is intermittent ● Are the batteries installed correctly? (p.
Maintenance Specifications First, remove the mains plug from the mains socket. ■ TV Display panel, Cabinet, Pedestal Regular care: Gently wipe the surface of the display panel, cabinet, or pedestal by using a soft cloth to remove dirt or fingerprints. For stubborn dirt: (1) First clean the dust from the surface. (2) Dampen a soft cloth with clean water or diluted neutral detergent (1 part detergent to 100 parts water). (3) Wring out the cloth firmly.
Aerial input Y 1.0 V[p-p] (including synchronisation) PB/CB, PR/CR UHF ±0.35 V[p-p] VHF / UHF HDMI 1 / 2 input TYPE A Connectors HDMI1: Content Type HDMI2: Content Type, Audio Return Channel ● This TV supports “HDAVI Control 5” function. Operating conditions Temperature 0 °C - 35 °C Humidity 20 % - 80 % RH (non-condensing) Built-in wireless LAN Card slot Standard compliance and Frequency range* Common Interface slot (complies with CI Plus) × 1 ETHERNET RJ45, IEEE802.3 10BASE-T / 100BASE-TX IEEE802.
■ When using the wall-hanging bracket Please contact your local Panasonic dealer to purchase the recommended wall-hanging bracket.
Disposal of Old Equipment and Batteries Only for European Union and countries with recycling systems These symbols on the products, packaging, and/or accompanying documents mean that used electrical and electronic products and batteries must not be mixed with general household waste. For proper treatment, recovery and recycling of old products and used batteries, please take them to applicable collection points in accordance with your national legislation.
