Operating Instructions

31
English
USB Contents
Playback Function
You can play back the contents (such as
photographs, movies, music, etc.) recorded in
the USB memory
*
on the projector.
*
Larger than 32 GB USB memory is not
supported.
File formats that can be played back
The following files can be played back in the
projector.
■ Gallery
Format: JPEG
● Number of pixels: 8000 × 8000 max.
(4096 × 4096 max. in the case of progressive
format)
● YUV format: Only YUV444, YUV422, and
YUV411 are supported
● Colour mode: Only RGB is supported
■ MoviePlayer
Format: MPEG1, MPEG2, MPEG4, H.264,
WMV/VC-1
● Resolution: 1920 × 1080 max.
240 × 180 min.
● Frame rate: 30 fps max.
● Bit rate: 40 Mbps max.
■ Music
Format: LPCM, MP1, MP2, MP3, AAC,
AC-3 (Dolby Digital), E-AC-3 (Dolby Digital Plus),
WMA, VORBIS, FLAC
● Sample rate: 48 kHz max.
(16 kHz max. in the case of linear PCM)
● Channel: 2 ch max.
● Bit rate: 3 Mbps max.
Note
● You cannot play back files that have
been protected by DRM (Digital Rights
Management).
● In some cases, files of a supported format can
also not be played back.
Using a USB memory
When inserting the USB memory
Properly insert the USB memory in
the USB terminal
Caution
● When inserting the USB memory, check
the direction of the plug and make sure the
terminal does not get damaged.
● While using the USB memory, such as during
playback, etc. do not turn off the mains
power of the projector, pull out the mains
plug, or remove the USB memory. Doing so
could damage the projector or cause data to
become corrupted.
When removing the USB memory
Remove the USB memory after
confirming that it is not being
accessed
Caution
● Take note of the following points when
removing the USB memory.
– If the indicator of the inserted USB memory
is flashing, it means that the projector is
reading data. Do not remove the USB
memory when the indicator is flashing.
– If the USB memory does not have a monitor
function such as an indicator, the status of
data reading cannot be known. Therefore,
remove the USB memory after closing the
USB contents playback screen, or after
turning off the mains power to the projector.
– Do not insert and remove the USB memory
within a short period of time. After inserting
the USB memory, wait for at least five
seconds before removing the USB memory,
and if the USB memory is to be inserted
again, wait for at least five seconds before
inserting it. The projector requires approx.
five seconds to recognize switching
between the insertion and removal of the
USB memory.