Operating Instructions

29
English
■ Reset to Defaults
Returns all settings of the sound to the settings
during shipment from the factory.
Basic
■ Keystone
Corrects the keystone distortion of the image that
occurs when the projector has been installed at
an angle, or when the screen is tilted.
■ Auto Standby
If no signal is input, or no operation is performed
for a certain amount of time, the projector
automatically turns off to reduce unnecessary
power consumption. (Changing the default
configuration may result in higher power
consumption of the product.)
•
No Signal:
Press the <OK> button to turn [ON] this item
so that the projector automatically turns off
under the following condition:
When the projector is not operated for approx.
10 minutes if no HDMI input signal is detected
during HDMI input
•
No Operation:
Press the <OK> button to turn [ON] this item
so that the projector automatically turns off
under the following condition:
When the projector is not operated for four
hours or more
■ Lamp Settings
Used to check the lamp usage period, or reset
the usage period when the lamp is replaced.
■ Projection Mode
Set the projection mode in accordance with the
installation state of the projector. If the screen
display appears inverted, change the projection
mode.
[Front]
When the projector is installed in front of the
screen
[Rear]
When the projector is installed at the back of
the screen (use a transmission type screen)
■ Off Timer
When you want to automatically turn off the
projector, select the time until the projector
is turned off ([30 minutes] / [60 minutes] /
[120 minutes]).
■ High Altitude mode
Change the settings when using the projector at
high lands.
[Off]
When the projector is used below 1500 m from
the sea level