Part| Basic Functions in this section, basic functions of voice, effect and rhythm are explained. For various storage functions that use the RECORD button, refer to Part ). Most buttons are equipped with indicators which light up when in operation. controls Volume and effects on this organ are controverted by 4-stage buttons, except the TRANSPOSE and RHYTHM TEMPO controls.
The circled numbers on the separate sheet correspond to the section numbers in this instruction manual. ® Orchestral Conductor {EX) The ORCHESTRAL CONDUCTOR is the nerve center of the Technicians organ. i allows you to instantly set up complete groups of voices or instrumental effects; you can even change them as you play. This adds a versatility to your playing that few professionals enjoy.
Tab Voices When the TAB VOICES button is turned on, the four Gluttons become FLUTE voice buttons. » Only FLUTE voices will sound when the TAB VOICES button is on. To use voices other than FLUTE voices, press the TAB VOICES button again to turn it off. The four FLUTE voices can be mixed as desired.
® Solo AN (O FILET O—my VOLUME FLUTE | [ SYNTH envious TRIM L —O BORE O—fir Taurus Fer | pong (EX10/EX20} All these sounds are monophonic, which means they will sound on only one key at a time no matter how many you press. W EX10/EX20: UPPER SOLO only is available. EX: you can select either UPPER or LOWER SOLO. VOLUME buttons let you adjust volume levels, ® Pedal Voices VOLUME om .
@ Transpose Suppose you learn to play a song--in the key of G, for example—and decide you want to sing it, only to find it's either tao high or too low for your voice. Your chalice is to either learn the song ali over again, in a different key, root use the TRANSPOSE feature. Techno-Chord TECHNO-CHORD makes your melodies sound like those of a professional organist by transferring the chord tones you play on the lower keyboard to each melody note you pay on the upper keyboard.
® Effect (chorus/Tremolo) c. (EX20/EX30) UPPER LOWER 5 UPPER LOWER EFFECT PP [ oL [Terrific] | VR L08R Erect ] R City o yous {1 poi row [} Py oy [fleeciness [ sow {1 ropy (e — O CELESTE CELESTE O CHARS continuous | favoritism cu onus) | revision oL (EX} (EX) {EX) The basic effect of TREMOLO is a rapid change in volume W EX20/EX30 {loudness). Ths two lower buttons are used to select effects.
@ Reuben {EX only} Reverb is an abbreviation for reverberation. If you've walked down a narrow, carpetbagged hallway, you may recall that your footsteps “schooled” or became louder than usual. This was due to the sound waves bouncing from the walls and ceiling instead of being absorbed into the carpeting, furniture and draperies. Because the furnishings in most rooms usually absorb all of the echo, your Technicians organ is equipped with REVERB o electronically replace the echo which is lost.
Voice Setting Computer COMPUTER 567 tarantella {EX) All voices and effects can be programmed into the VOICE SETTING COMPUTER. NOTE: No slide control setting can be recorded in the computer. The button marked CANCEL lets you shut off the VOICE SETTING COMPUTER and change to standard organ sounds. Buttons 1~4 (EX) or 1~7 {EX} are used to store the voices and effects for both keyboards and pedals. 1. Set the registration. . With the SET button held down, press the 1 button.
Fill in & Intro This feature lets you use a one-measure drum solo {or "fill”} as an introduction to a song, or to connect different sections of a song. Using the 8 BEAT rhythm, let's see how this quarks, As an intro (introduction): 1. Press 8 BEAT. Fill 1N & INTRO FILL IN & INTRO {EX} {EX20/EX30) 2. Press FILL IN & INTRO—the indicator lights up. 3. Start the rhythm (press START/STOP). You'll hear the drums start with the intro and continue on to the 8 BEAT rhythm. After the intro, the indicator goes out.
One Touch Play i this button is pressed, the appropriate tone and effect registration for the rhythm chosen are automatically set. Therefore, immediate play is possible if a rhythm is selected and this button is pressed for several seconds until the button stops flashing. Play Mode These bunions are used to select the desired type of accompaniment, ¥ Normal mode (PCC and FINGERED buttons are off} * The accompaniment is formed from the pedal and lows keyboards.
Auto Play Chord Auto Piaf Chord is an effective musical aid and a source of enjoyment regardless of your previous musical experience. Combined with other exciting Technicians features—Automatic Rhythm, and Flay Chord can help you create orchestral and full organ sounds using only one finger on each hand, Further, it can actually help you learn to play the organ in the traditional manner. Let's see how. ..
Part Il Storage Functions Refer to Part parentheses following the heading.} @ Record Record creates no effect of its own. This bunion is used to store functions such as the PROGRAM CHORD COMPUTER. When you press RECORD, its indicator and the indicators of all programmable features flash quickly. Press the button for the feature you wish to use. its indicator will flash slowly and the indicators of the other features will go out.
@ Program Chord Computer ‘The PROGRAM CHORD COMPUTER, complete with a memory bank, is an amazing device that is exclusive to most Technicians organ models. That's right—a computer built into the Technicians organ! This makes it possible for you to program the chord accompaniment of an entire song and stare it right inside the organ.
Storing Chords in the Computer 1. Press RECORD and then PCC. Computer memory is now ready to receive the chords in the example. Press and hold the C chord on your lower keyboard, either in the on-finger or fingered mode. DON'T PRESS THE FINGERED BUTTON however, since doing so cancels the record feature. While holding the C chord press the key marked ¥ . The chord sounds while you're holding it; as you press the >} key, you'll hear a tiles you the chord is now in the memory.
Modifying or Correcting Programmed Chords Suppose you wanted to change the A7 chord in the example 7—here are & couple of ways you could do it Using the Rhythm 1. Press the RECORD and PCC buttons. 4, Play and hold the new chord (E b 7) and press the ey key. The new chord is now in the position of the original 2. Press START/STOP to begin the chord sequence with the chord. rhythm. 5. Press PCC again. 3. Stop the rhythm when the sequence reaches the A7 chord.
Voice, Fill in & Intro, Ending Storage This PROGRAM CHORD COMPUTER stores not only chords but also the FILLING & INTRO and ENDING. On the EX20/EX30, voices from the VOICE SETTING COMPUTER can also be stored. M For Fill iN & INTRO, ENDING Storage ® For Voice Storage INTRO Before storing a chord, press 2 VOICE SETTING COMPUTER Storage can be done by pressing the FILLING & INTRO button at number button. This stores the selected voice at the the beginning of a tune. beginning of the next measure.
@ "0'03 settee“ telecommute‘ (EX20/EX30) How te Use the Factory-Prates USC In addition to your own registrations, the 32 factory-preset voice combinations (16X2} allow you to choose your favorites for storage in VOICE SETTING COMPUTER buttons 1~4 (EX) or 1~7 (EX30). 1. Press the RECORD button. 2. Press the 1 button to store the desired voices. 3. |f you press RHYTHM button(s), a registration appropriate for the rhythm is selected.
@ Program Function Switch ., The function desired during play can be stored in the foot switch, Thus, the voice and effects can be easily changed with your foot, » The switch normally works as a glide switch. * Functions for storage START/STOP VOICE SETTING COMPUTER (EX: 1~4, EX: 1~7} CHORUS/TREMOLO ] * When the CELESTE is selected, CHORUS and TREMOLO cannot be interchanged using the foot switch {EX20/EX30}. TECHNO-CHORD FILLING & INTRO (EX: ON, EX20/EX30: |, {l, SOLO) ENDING For Storage 1.
@ Tremolo Speed Adjustment 3 UPPER LOWER Al UPPER val— Lower [SNEEZE] [ e e erect POLY POLY Pal Y POLY POLY SPECIAL SOLS POLY 0= = O CELESTE Oy e O CELESTE CHORUS] | TREMBLE] CHORUS [tremolo ] {EX) {EX} {EX) The Technicians organ allows the TREMOLO speed tc be * The CHORUS and CELESTE (EX20/EX30) speeds remain adjusted. The TREMOLO creates an effect like two speakers unchanged during this adjustment, rotating at different speeds. The fast and slow speeds are * Adjustment range both adjustable.
Part Iil Storage of Performance Contents Full band Setting Computer The FULL BAND SETTING COMPUTER (FSC) is used to set tones, affects and rhythm combinations. It also allows storage in the memory of information needed to play sangs such as the contents stored in the PROGRAM CHORD COMPUTER. The stored contents can be freely retrieved for use whenever required. ® The contents for up to five tunes, excluding the performance, can be stored.
Let's read out the stored FSC contents to set the tones and effects . Press the F§C Hutton. . Press the key on the lower keyboard that corresponds to the number of the song you wish to play. The tones and effects played at the beginning of the song will be indicated by the button indicators. Atheistic, the FSC indicator flashes to show that settings have been made correctly. If the VOICE SETTING COMPUTER indicators flash, an error is indicated.
HL. To Store Other Parts for Automatic Performance (Multiplex Storage) 1. Turn off all four PLAY SEQUENCER buttons. . Press the RECORD button. its indicator will flash. . Press the PLAY SEQUENCER button for the part to be stored first, ts indicator will fish slowly. . Play the part to be stored. . After playing the part, press the PLAY SEQUENCER button forth next part to be stored. its indicator will flash slowly. The rhythm automatically stops.
V. Registration Storage B Registration Storage When PLAY SEQUENCER storage operation is performed, the contents set before the RECORD button is pressed are automatically stored in the memory. & Checking and modifying registration before performance When the RECORD and PLAY SEQUENCER indicators flash before performance, no modification or addition can be stored. [ you wish to check or modify the registration, turn on the FSC button. After checking and modifying the contents, turn off the FSC button.
@D Connection Terminals {On the rear of the organ} UNE QT AW el {EX10/EX20} UNE 09T AKX s X1 uop {EX) LINE-OUT (output feel 300 mV, 60002} PHONES hugging into a high-power amplifier, the organ sound, For silent practice headphones may be used. When plugged using microphone and auxiliary instruments, can be in, the organ’s speaker system is automatically switched off, reproduced at a very high volume level. The organ can also and the entire organ is heard only through the headphones.
Phenomenon Remedy ‘The TREMOLO speed is improper. The TREMOLO speed is adjustable, Adjust to your favorite speed. (Refer to @) The contents of the PROGRAM CHORD COMPUTER, FULL BAND SETTING COMPUTER (EX20/EX30), etc. cannot be stored After pressing the RECORD button, press the necessary buttons within & seconds, The RECORD button turns off after a lapse of 5 seconds, making storage operation impossible.
@ Cautions for Safest Use of This Unit Installation location 1. A well-ventilated place, Take care not to use this unit in a place where it will not receive sufficient ventilation, and not to permit the ventilation holes to be covered by curtains, or any similar materials. 2. Place away from direct sunlight and excessive heat from heating equipment, 3. Place where humidity, vibration and dust are minimized. Power source 1.
