Datasheet

SFY
–4–
ASCTB317E 201512-T
Other contact gaps when contacts are welded
The table below shows the state of the other contacts.
In case of form “NO” contact weld the coil applied voltage is 0 V.
In case of form “NC” contact weld the coil applied voltage is nominal.
<2 Form A 2 Form B>
<3 Form A 1 Form B>
<4 Form A 2 Form B>
<5 Form A 1 Form B>
>0.5: contact gap is kept at min. 0.5 mm .020 inch
Empty cells: either ON or OFF
Note: Contact gaps are shown at the initial state.
If the contact transfer is caused by load switching, it is necessary to check the actual loading.
State of other contacts
3-4 (NC) 5-6 (NC) 7-8 (NO) 9-10 (NO)
Welded
terminal
No.
3-4 (NC) >0.5 >0.5
5-6 (NC) >0.5 >0.5
7-8 (NO) >0.5 >0.5
9-10 (NO) >0.5 >0.5
State of other contacts
3-4 (NC) 5-6 (NO) 7-8 (NO) 9-10 (NO)
Welded
terminal
No.
3-4 (NC) >0.5 >0.5 >0.5
5-6 (NO) >0.5
7-8 (NO) >0.5
9-10 (NO) >0.5
State of other contacts
3-4 (NC) 5-6 (NC) 7-8 (NO) 9-10 (NO) 11-12 (NO) 13-14 (NO)
Welded
terminal
No.
3-4 (NC) >0.5 >0.5 >0.5 >0.5
5-6 (NC) >0.5 >0.5 >0.5 >0.5
7-8 (NO) >0.5 >0.5
9-10 (NO) >0.5 >0.5
11-12 (NO) >0.5 >0.5
13-14 (NO) >0.5 >0.5
State of other contacts
3-4 (NC) 5-6 (NO) 7-8 (NO) 9-10 (NO) 11-12 (NO) 13-14 (NO)
Welded
terminal
No.
3-4 (NC) >0.5 >0.5 >0.5 >0.5 >0.5
5-6 (NO) >0.5
7-8 (NO) >0.5
9-10 (NO) >0.5
11-12 (NO) >0.5
13-14 (NO) >0.5