Operating Instructions

9
RQT8672
3 Attach the speaker to the stand.
1 Pull out the end of the speaker cable and
position it between the ridges.
2 Attach the speaker to the stand.
4 Secure the speaker to the stand. 5 Connect the speaker cable.
Preventing the front and surround speakers from falling over
Cable
Ridges
Stand
Cover plate
Before attaching the speaker,
use a flathead screwdriver
carefully to remove the cover
plate, and keep for wall-mount
use (➡ 17).
Speaker
Stand
Stand
Speaker
Screw
Tighten securely.
Ensure the speaker cable is
centered in the groove.
_: White
`: Blue
Insert the wire fully.
Press the speaker cable into the groove.
Push!
To prevent the speaker from falling over, thread the string
(not included) from the wall to the speaker as shown and
tie tightly.
Rear of the speaker
Screw eye (not included)
Wall
Approx.
150 mm
String (not included)
STEP 1 Front and surround speaker assembly
[RT70]
Preparation
Attach screw eyes (not included) to secure the speakers to
the wall (➡ diagram right).
≥You will need to obtain the appropriate screw eyes to
match the walls or pillars to which they are going to be
fastened.
≥The walls or pillars to which the screw eyes are going to
be fastened should be capable of supporting 20 kg.
Consult a qualified housing contractor concerning the
appropriate procedure when attaching to a concrete wall
or a surface that may not have strong enough support.
Improper attachment may result in damage to the wall or
speakers.
RT70-30.book Page 9 Thursday, April 13, 2006 1:45 PM