Operating Instructions

4
RQTX0226
Quick Start Guide
Getting Started
[PT570] Front speaker
[PT870] Front and surround speakers
Preparation
≥ To prevent damage or scratches, lay down a soft cloth and perform
assembly on it.
≥ For assembly, use a Phillips-head screwdriver (not included).
≥ You will need to obtain the appropriate screw eyes to match the walls
or pillars to which they are going to be fastened.
≥ Consult a qualified housing contractor concerning the appropriate
procedure when attaching to a concrete wall or a surface that may not
have strong enough support. Improper attachment may result in
damage to the wall or speakers.
e.g. Front speaker
Caution
Do not stand on the base. Be cautious when children are near.
step 1 Assembling the speakers
Speaker assembly option
[PT570]
[PT870]
2 Front speakers
2 Front speakers
2 Surround speakers
[PT570]
[PT870]
2 Stands (with cable)
4 Stands (with cable)
[PT570]
2 Bases
[PT870]
4 Bases
[PT570]
8 Screws
[PT870]
16 Screws
Make sure you have all the indicated components before starting assembly, setup, and connection.
≥ Keep the screws out of reach of children to prevent swallowing.
≥ For optional wall mount, refer to page 23.
1
2
2
1
Slide into the groove.
Press into the groove.
Tighten securely.
Tighten securely.
Insert the wire fully.
Push!
Position the cable
between the ridges.
Leave about 120 mm.
: White
: Blue
Thread the speaker cable through
the base.
Attach the speaker.
Insert the wire fully.
Push!
: White
: Blue
Slide into
the groove.
Press into the groove.
Tighten securely.
You can remove and use the
cable from the stand. To reattach
the cable, refer to page 23.
Leave about
120 mm.
Preventing the speakers from falling
String (not included)
Wall
Approx.
150 mm
Screw eye
(not included)
Rear of the
speaker
Thread from the wall to the speaker and tie tightly.
e.g. Front speaker
DO
NOT
RQTX0226-R_eng.book Page 4 Saturday, December 20, 2008 11:04 AM