Operating Instructions

Making the connections
Connect the AC mains lead only after all the other connections have been made.
1 Connect the DAB/FM antenna.
Be sure to tighten fully the nut.
Rotate the antenna at to improve reception.
2 Connect the speakers.
3 Connect the AC mains lead.
Preparing the remote control
Use alkaline or manganese battery.
Install the battery so that the poles (+ and –) align with those
in the remote control.
1
2
3
Be careful not to cross
(short-circuit) or reverse the
polarity of the speaker wires
as doing so may damage the
speakers.
Adhesive tape
(not supplied)
Red
Black
To household
mains socket
(not supplied)
Overview of controls
Do the procedures with the remote control. You can also use the buttons on the main unit if they are the
same.
A
Standby/on switch [`], [1]
Press to switch the unit from on to standby mode or vice
versa. In standby mode, the unit is still consuming a
small amount of power.
B Select the audio source
On the main unit:
Press [SELECTOR] repeatedly to select the source:
To start Bluetooth
®
pairing, press and hold
[– PAIRING].
C Basic playback control
D View the setup menu
E View the content information
F Select and confirm an option
Skip MP3 albums
G Open or close the disc tray
H Decrease the brightness of the display panel
To cancel, press the button again.
I Adjust the volume level
J Mute the sound
To cancel, press the button again.
“MUTE” is also cancelled when you adjust the volume or
when you switch off the system.
K View the play menu
L Select the sound effects
M Disc tray
Put in a disc with the label facing up.
N Remote control sensor
Distance: Within approximately 7 m
Angle: Approximately 10° up and 30°down, 30° left and
right
O Display panel
P Headphones jack ( )
Plug type: Ø 3.5 mm stereo (not supplied)
– Excessive sound pressure from earphones and
headphones can cause hearing loss.
– Listening at full volume for long periods may damage
the user’s ears.
Q USB port (DC 5V 500 mA)
Rear
Play Press [4/9].
Stop Press [8].
Pause Press [4/9].
Press again to continue playback.
Skip Press [2/3] or [5/6].
Search Press and hold [2/3] or [5/6].
Basic operations
Bluetooth
®
Preparation
Switch on the Bluetooth
®
feature of the device and put the device near the system.
█ Pairing a device
1 Press and hold [– PAIRING] on the main unit until “PAIRING” is shown.
2 Select “SC-PM702/PM704” from the Bluetooth
®
menu of the device.
█ Connecting a device
1 Press [ ].
2 Select “SC-PM702/PM704” from the Bluetooth
®
menu of the device.
3 Start playback on the device.
FM Radio
1 Press [RADIO] repeatedly to select “FM”.
2 Press [PLAY MENU] repeatedly to select “TUNE MODE”.
3 Press [ R , T ] to select “MANUAL” and then press [OK].
4 Press [2/3] or [5/6] to tune in to the station.
To tune automatically, press and hold the button until the frequency starts changing quickly.
DAB+
1 Press [RADIO] repeatedly to select “DAB+”.
If you select “DAB+” for the first time, the system will tune automatically.
2 Press [PLAY MENU] repeatedly to select “MANUAL SCAN”.
3 Press [R, T] to select the frequency block and then press [OK].
If no station is detected, “SCAN FAILED” is shown.
Adjust the antenna and try again.
PM702EB_TQBM0876_en.fm Page 2 Monday, February 20, 2023 10:20 AM